2
BREAKING IN YOUR VEHICLE
Operate the vehicle at moderate
speeds during the first 1,000 km
(600 miles) to break it in. Make
certain that the following points in
particular are strictly observed.
荫 Allow the engine to warm up
fully until the coolant temperature
reaches about 60益(140毅F).
荫 Avoid racing the engine, abrupt
start, acceleration and braking.
荫 Avoid overloading the vehicle,
as this will result in a shorter life.
荫 Avoid high speed operation as
far as possible. During break in
operation, make sure that the en鄄
gine speed does not exceed 1,500
rpm.
Make sure that your vehicle does
not miss the first 1,000 km (600
miles) and 5,000 km (2,500 miles )
inspections.
After the first 1,000 km (600 miles)
and 5,000 km (2,500 miles) or driv鄄
ing, take your vehicle to your near鄄
est service shop for inspections
based on the "Maintenance Re鄄
quirements".
KEYS
For greater convenience, your JAC
has one type of keys. The keys will
function in the ignition, locking or
unlocking the door and fuel tank
cap from outside. Carrying a spare
key is recommended in case you
accidentally lock one key inside
the car.
KEY LOCKS
You can release the key by press鄄
ing the knob when the key is in
"LOCK" position.
DOOR LOCKS
BEFORE DRIVING YOUR VEHICLE
3
1. Locking using the key
Lock the door by turning the key
toward the rear of the car and un鄄
lock it by turning it toward the
front.
2. Locking from inside
To lock your JAC from inside, sim鄄
ply close the door and push the
lock button down. When this is
done, the door cannot be opened
using either the inside or the out鄄
side door handle.
3. Locking from outside
The doors can be locked without a
key.
First push the lock knob down,
then close the door while depress鄄
ing the push button forward.
KEYLESS ENTRY SYSTEM (If in鄄
stalled)
THEFT ALARM SYSTEM
Armed Status
The system is applied when the
doors are locked by using the
CAUTION:
Be careful not to lock the door
with the ignition key left in the
vehicle.
NOTE:
When the door is open or ajar,
the warning lamp door will light
on.