|
|
AV DIAGNOSIS SYSTEM (AROUND VIEW MONITOR CONTROL UNIT) AV-189 < SYSTEM DESCRIPTION > [NAVIGATION (SINGLE MONITOR)] C D E F G H I J K L M B A O P DIAGNOSIS SYSTEM (AROUND VIEW MONITOR CONTROL UNIT) On Board Diagnosis Function INFOID:0000000005511924 The diagnosis function of around view monitor control unit is displayed when selecting “Camera Cont.” of Con- Around view monitor control unit diagnosis item CAUTION: *: Never perform other operations for approximately 10 seconds after performing "Initialize Camera Connection Confirmation The status of signals inputted to around view monitor control unit can Connection Confirmation item list AV control unit Confirmation/Adjustment mode Function Camera Cont. Connection Confirmation The status of signals input to around view monitor control unit Calibrating Cam- Rear Camera Performs the calibration of rear camera. Pass-Side Camera Performs the calibration of side camera RH. Front Camera Performs the calibration of front camera. Dr-Side Camera Performs the calibration of side camera LH. Initialize Camera Image Calibration * The calibration can be initialized to NISSAN factory shipment Fine Tuning of Birds-Eye View • The confirmation and adjustment of the difference between each camera can be performed. • The system changes to the ZOOM function by the operation of shift and the ZOOM ratio of each camera can be changed. Correct Draw Line Rear-Wide View The position of rear wide view guideline can be changed. JSNIA2277ZZ Diagnosis item Display Description Steer. Angle Sensor ON/OFF • Input status of steering angle sensor is displayed by ON/OFF. ON until connection confirmation mode is stopped. Reverse Sensor ON/OFF Input status of reverse signal inputted to around view monitor control unit is dis- Vehicle Speed Sensor ON/OFF • Input status of vehicle speed signal inputted to around view monitor control unit is displayed by ON/OFF. • When the vehicle speed signal is input, it is turned ON. It remains ON until con- nection confirmation mode is stopped. Camera Switch ON/OFF • The status of camera switch signal received via AV communication from NAVI control unit is displayed by ON/OFF. • When the camera switch signal is received once, it is turned ON. It remains ON until connection confirmation mode is stopped. IGN ON/OFF Input status of ignition signal inputted to around view monitor control unit is dis- |