Hyundai Santa Fe (2019 year). Instruction - part 40
Specifications & Consumer information
Lubricant
Volume
Classification
Petrol
Theta II 2.4MPI
7.1 l (6.24 lmp. qts.)
MICHANG ATF SP-IV,
Engine
Theta II 2.4GDI
6.7 l (5.90 lmp. qts.)
Automatic transmission
SK ATF SP-IV,
fluid
R2.0
7.0 l (6.16 lmp. qts.)
NOCA ATF SP-IV,
Diesel
HYUNDAI genuine ATF SP-IV
Engine
R2.2
7.1 l (6.24 lmp. qts.)
MT : 7.9 l (7.0 lmp. qts.)
Petrol
Theta II 2.4 MPI
AT : 8.2 l (7.2 lmp. qts.)
engine
Mixture of antifreeze and distilled water
Theta II 2.4 GDI
8.2 l (7.2 lmp. qts.)
Coolant
(Ethylene glycol base coolant for
R2.0
8.8 l (7.7 lmp. qts.)
aluminium radiator)
Diesel
8.8~9.0 l
Engine
R2.2
(7.7 ~ 7.9 lmp. qts.)
0.44~0.48 l
Brake/clutch fluid
FMVSS116 DOT-3 or DOT-4
(0.39 ~ 0.42 lmp. qts.)
Rear differential oil (4WD)
0.58 l (0.51 lmp. qts.)
HYPOID GEAR OIL API GL-5, SAE 75W/85
(SK HCT-5 GEAR OIL 75W/85 or
Transfer case oil (4WD)
0.45 l (0.40 lmp. qts.)
EQUIVALENT)
Refer to Fuel requirements in the introduction
Fuel
71 l (15.61 lmp. gal.)
chapter.
Urea solution (Diesel Engine)
18 l (15.84 lmp. qts.)
ISO22241, DIN70070
8-8
Recommended engine oil
Supplier
Product
Helix Ultra AH 5W30
Petrol Engine
Helix Ultra A5/B5 0W30
Shell
Helix Ultra ECT AH 5W30
Diesel Engine
Helix Ultra ECT C2/C3 0W30
Recommended SAE viscosity number
CAUTION
Always be sure to clean the area around any filler plug, drain plug, or dipstick before checking or draining
any lubricant. This is especially important in dusty or sandy areas and when the vehicle is used on unpaved
roads. Cleaning the plug and dipstick areas will prevent dirt and grit from entering the engine and other
mechanisms that could be damaged.
Engine oil viscosity (thickness) has an effect on fuel economy and cold weather operating (engine start and engine
oil flowability). Lower viscosity engine oils can provide better fuel economy and cold weather performance, however,
higher viscosity engine oils are required for satisfactory lubrication in hot weather. Using oils of any viscosity other
than those recommended could result in engine damage.
8
8-9
Specifications & Consumer information
When choosing an oil, consider the range of temperature your vehicle will be operated in before the next oil change.
Proceed to select the recommended oil viscosity from the chart.
Temperature Range for SAE Viscosity Numbers
*1 :For better fuel economy, it is recom-
mended to use the engine oil of a vis-
°C
-30
-20
-10
0
10
20
30
40
50
Temperature
cosity grade SAE 5W-30 (ACEA A5).
(°F)
-10
0
20
40
60
80
100
120
However, if the engine oil is not avail-
20W-50
able in your country, select the prop-
Petrol Engine Oil*1
15W-40
er engine oil using the engine oil vis-
(2.4L MPI)
10W-30
cosity chart.
0/5W-30, 5W-40
20W-50
Petrol Engine Oil
15W-40
(2.4 GDI)
10W-30
5W-30, 5W-40
15W-40
10W-30/40
Diesel Engine Oil
5W-30/40
0W-30/40
8-10
VEHICLE IDENTIFICATION NUMBER (VIN)
VEHICLE CERTIFICATION
■ Frame number
■ VIN label (if equipped)
LABEL
OTM088003
OTM088008L
The vehicle identification number
The VIN is also on a plate attached
OTM088001R
(VIN) is the number used in register-
to the top of the left side dashboard.
The vehicle certification label
ing your vehicle and in all legal mat-
The number on the plate can easily
attached on the driver’s (or front pas-
ters pertaining to its ownership, etc.
be seen through the windscreen
senger’s) side centre pillar shows the
from outside.
The number is punched on the
vehicle identification number (VIN).
engine compartment frame and back
side of the engine.
8
8-11
Specifications & Consumer information
TYRE SPECIFICATION AND
ENGINE NUMBER
PRESSURE LABEL
■ Petrol engine (Theta 2.4 MPI)
■ Diesel engine
OTM088006L
OTM088004
OTM078063R
■ Petrol engine (Theta 2.4 GDI)
The engine number is stamped on the
engine block as shown.
The tyres supplied on your new vehi-
cle are chosen to provide the best
performance for normal driving.
The tyre label located on the driver's
side centre pillar shows the tyre
pressures recommended for your
vehicle.
OTM088009L
8-12
AIR CONDITIONER
REFRIGERANT LABEL
DECLARATION OF
COMPRESSOR LABEL
(IF EQUIPPED)
CONFORMITY (IF EQUIPPED)
■ Example
OHC081001
OTM088010L
CE0678
A compressor label informs you the
The refrigerant label provides infor-
The radio frequency components of
type of compressor your vehicle is
mation such as refrigerant type and
the vehicle comply with requirements
equipped with such as model, suppli-
amount.
and other relevant provisions of
er part number, production number,
The label is located on the underside
Directive 1995/5/EC.
refrigerant (1) and refrigerant oil (2).
of the bonnet.
Further information including the
manufacturer's declaration of con-
formity is available on HYUNDAI
web site as follows;
8
8-13