Hummer H1 (2006+). Manual - part 355
12-96
Electrical System
_______________________________________________________
Programming the Selectable Features
1.
To start programming, make sure that the Theft Deterrent System is disarmed, either by using a remote transmitter that is cur-
rently programmed, or by using the Theft Deterrent System Override procedure.
2.
Gain access to the programming push button switch located on the keyless entry control module, which is mounted in the
center console of the vehicle.
3.
Turn the ignition key to the “ON” position.
4.
Within 15 seconds, press and release the programming Switch 3 times. The vehicle's horn will sound one time indicating that
the system is in remote transmitter program mode.
5.
Immediately turn the ignition key off (3 chirps indicates exit remote transmitter program mode) and then back on. The
vehicle's horn will sound 2 chirps indicating that the system is in feature programming mode.
6.
Press and release the programming switch on the keyless entry module 1 time to advance to feature number 1. The vehicle's
horn will chirp 1 time if feature 1 is in the “ON” position, or 2 times if feature 1 is in the “OFF” position
7.
To change the feature, press and release the “LOCK” button on the keyless entry remote transmitter, and the appropriate 1 or 2
chirp signal from the horn will identify the new selection for that feature (Refer to the table shown above).
8.
To advance to selectable feature number 2, press and release the programming switch on the keyless entry module a second
time, and again the vehicle's horn will identify the selection of that feature. Use the lock button on the keyless entry remote
transmitter to change the feature or proceed to the next step if no change is desired
Feature
Number
Function
ON
One Chip Indication
OFF
Two Chip Indication
1
Auto ignition lock.
ON or OFF
Factory preset = ON
When this feature is selected
“ON”, 3 seconds after the ignition
key is turned on, all doors will
automatically lock. If a door is
opened when the key is turned on,
the doors will not auto lock.
When this feature is selected “Off”,
The doors will not automatically
lock when the ignition key is turned
on.
2
Auto Ignition Driver’s Door Unlock.
ON or OFF
Factory Pre Set = ON
When this feature is selected “ON”,
the driver’s door will automatically
unlock immediately after the igni-
tion key is switched from the “ON”
to the “OFF” position.
When this feature is selected “OFF”,
the driver’s door will not automati-
cally unlock when the ignition key is
turned “OFF”
3
Auto Ignition Passenger Doors Unlock.
ON or OFF
Factory Pre Set = OFF
When this feature is selected “ON”,
the remaining passenger doors will
automatically unlock immediately
after the ignition key is switched from
the “ON” to the “OFF” position.
When this feature is selected “OFF”
the remaining passenger doors will
not automatically unlock when the
ignition key is turned “OFF”.
4
Active or Passive Alarm Arming.
Factory Pre Set = Active
When this feature is selected
“ON” or “ACTIVE” the Theft
Deterrent System will only arm
after the “LOCK” button on the
transmitter is pressed. (The doors
will automatically lock).
When this feature is selected “OFF”
or “PASSIVE”, the Theft Deterrent
System will automatically arm 30
seconds after the ignition key is
turned off and a door is opened then
all doors are closed.
5
Active or Passive Door Locking
Factory Pre Set = Active
When this feature is selected “ON”
or “ACTIVE”, the vehicle’s doors
will only lock when the “LOCK”
button on the transmitter is pressed.
When this feature is selected ”OFF” or
“PASSIVE”, and feature number 4 is
set to “PASSIVE”, all doors will auto-
matically lock 30 seconds after the
ignition key is turned “OFF” and a door
is opened then all doors are closed.