12.4.3.3 Rear Bumper Replacement (Sedan)

Removal Procedure:

FE12-0156b

1.

Remove the two rear bumper upper retaining screws, two
clips, six rear bumper to rear wheelhouse liner retaining
bolts and four rear bumper to spare wheel carrier retaining
bolts.

FE12-0157b

2.

Remove  the  rear  compartment  trim  panel.  Refer  to

12.9.1.9

 

Rear Compartment Trim Panel Replacement

.

3.

Remove the rear bumper left and right retaining bolts.

FE12-0152b

4.

Remove four rear park assist sensor harness connectors.

5.

Remove  four  rear  park  assist  sensors.  Refer  to

11.14.7.2

 

Reverse Radar Sensor Replacement

.

Body, Sheet Metal and Painting

Bumpers

12-33

FE12-0158b

6.

Remove  the  rivets  from  the  rear  bumper  mounting
brackets and remove the rear bumper mounting brackets.

Installation Procedure:

FE12-0158b

1.

Install  the  rear  bumper  mounting  brackets  to  the  rear
bumper.

2.

Install four rear park assist sensors.

3.

Connect four rear park assist sensor harness connectors.

FE12-0159b

4.

Install the rear bumper left and right retaining bolts.

5.

Install the two rear bumper upper retaining screws, two
clips, six rear bumper to rear wheelhouse liner retaining
bolts and four rear bumper to spare wheel carrier retaining
bolts.

6.

Install the rear compartment trim panel.

12-34

Bumpers

Body, Sheet Metal and Painting

12.4.3.4 Front Impact Bar Replacement

Removal Procedure:

FE12-0160b

1.

Remove the front bumper. Refer to 

12.4.3.1

 

Front Bumper

Replacement

.

2.

Remove the front impact bar retaining nuts.

FE12-0161b

3.

Remove  four  retaining  nuts  from  each  side  of  the  front
bumper energy absorber.

Installation Procedure:

FE12-0162b

1.

Install four retaining nuts on each side of the front bumper
energy absorber.

Torque: 70 Nm (Metric) 51.8 lb-ft (US English)

Body, Sheet Metal and Painting

Bumpers

12-35

FE12-0163b

2.

Install four front impact bar retaining nuts.

Torque: 70 Nm (Metric) 51.8 lb-ft (US English)

3.

Install the front bumper.

12.4.3.5 Rear Impact Bar Replacement

Removal Procedure:

FE12-0164b

1.

Remove the rear bumper. Refer to 

12.4.3.3

 

Rear Bumper

Replacement (Sedan)

.

2.

Unclip the wiring harness clips.

3.

Remove four retaining nuts from the rear impact bar .

FE12-0165b

4.

Remove  four  retaining  bolts  from  each  side  of  the  rear
bumper energy absorber.

12-36

Bumpers

Body, Sheet Metal and Painting