FE11-0286b

5.

Hold  down  the  license  plate  tongue  and  remove  the
license plate lamp.

6.

Remove the license plate lamp bulb.

Installation Procedure:

FE11-0287b

1.

Install the license plate lamp bulb.

Note

Avoid touching the bulb or letting the bulb to come
into contact with any moist. When the lamp is turned
on, the grease or moisture on the bulb may cause
the bulb explode. If the bulb contacts with grease or
moisture,  clean  the  bulb  with  alcohol  or  an
appropriate cleaning agent and dry the bulb.

2.

Press the license plate lamp into the mounting hole on the
rear compartment lid.

3.

Install the rear compartment lid applique.

FE11-0288b

4.

Connect the license plate lamp harness connector.

5.

Install the rear compartment lid trim panel.

6.

Connect the battery negative cable.

Body Electric

Lighting System

11-145

11.4.8.15 Door Lamp Replacement

Removal Procedure

FE11-0289b

1.

Remove the door lamp cover.

FE11-0290b

2.

Remove the door lamp bulb.

Installation Procedure:

FE11-0291b

1.

Install the door lamp bulb.

Note

Avoid touching the bulb or letting the bulb to come
into contact with any moist. When the lamp is turned
on, the grease or moisture on the bulb may cause
the bulb explode. If the bulb contacts with grease or
moisture,  clean  the  bulb  with  alcohol  or  an
appropriate cleaning agent and dry the bulb.

11-146

Lighting System

Body Electric

FE11-0292b

2.

Install the door lamp cover.

11.4.8.16 Reverse Switch Replacement

Removal Procedure

Warning!

Refer to "Battery Disconnect Warning" in "Warnings and
Notices".

2

1

FE11-0293b

1.

Disconnect  the  battery  negative  cable.  Refer  to

2.11.8.1

 

Battery Disconnection

.

2.

Disconnect the reverse switch wiring harness connector
(1).

3.

Remove the the reverse switch from the gearbox (2).

Body Electric

Lighting System

11-147

Installation Procedure:

1

2

FE11-0294b

1.

Install and tighten the reverse switch (1).

Torque: 40 Nm (Metric) 30 lb-ft (US English)

2.

Connect the reverse switch harness connector 2.

3.

Connect the battery negative cable.

11.4.8.17 Brake Lamp Switch Replacement

Removal Procedure

Warning!

Refer to "Battery Disconnect Warning" in "Warnings and
Notices".

1

2

FE11-0295b

1.

Disconnect  the  battery  negative  cable.  Refer  to

2.11.8.1

 

Battery Disconnection

.

2.

Disconnect  the  brake  lamp  switch  wiring  harness
connector (1).

3.

Release the locking nut, loose and remove the switch from
the brake pedal bracket (2).

11-148

Lighting System

Body Electric