FE03-0128b

4.

Install the 1st and 2nd gear synchronizer snap ring.

FE03-0129b

5.

Install the 2nd gear needle bearing snap ring.

FE03-0130b

6.

Install the 2nd gear needle bearing.

Transmission / Drive Axle

Manual Transmission

3-99

FE03-0131b

7.

Install the 2nd gear.

FE03-0132b

8.

Install the 3rd gear with a special tool GL201-003.

Note

The 3rd gear need to be pressed into the position,
with the convex side up.

FE03-0133b

9.

Install the sleeve between the 3rd gear and the 4th gear.

3-100

Manual Transmission

Transmission / Drive Axle

FE03-0134b

10. Install the 4th gear with a special tool GL201-003.

Note

The 4th gear need to be pressed into the position,
with the convex side up.

FE03-0135b

11. Install the 5th gear with a special tool GL201-003.

Note

The 5th gear need to be pressed into the position,
with the convex side up.

FE03-0136b

12. Install the 5th gear snap ring.

Transmission / Drive Axle

Manual Transmission

3-101

FE03-0137b

13. Install  the  main  shaft  rear  bearing  with  a  special  tool

GL201-007.

Note

If  the  bearings  need  to  be  replaced,  the  bearing
outer  ring  also  need  to  be  replaced.  During  the
removal, please use a special tool GL201-006. After
the installation of the transmission rear case, please
use a special tool GL201 - 008 to adjust the bearing
pre-load.

14. Install the main shaft assembly.

15. Install the shift shaft.

16. Install the shift control assembly.

17. Install the transmission.

3.3.8.9 Shift Lever Replacement

Removal Procedure:

Warning!

Refer to "Battery Disconnect Warning" in "Warnings and
Notices".

FE03-0138b

1.

Disconnect  the  battery  negative  cable.

2.11.8.1

 

Battery

Disconnection

.

2.

Remove the center console upper panel and Disconnect
the harness connector.

3-102

Manual Transmission

Transmission / Drive Axle