|
|
содержание .. 201 202 203 204 205 ..
Geely EC718, EC718RV, EC715, EC715RV. Manual part - 204
Next Step 10 Use scan tool to confirm whether the DTC code is stored again. (a) Connect scan tool to the datalink connector. (b) Turn the ignition switch to "ON" position. (c) Clear DTC code. (d) Start and run the engine at idle speed to warm up the engine (e) Road test the vehicle for at least 10 min. (f) Read control system DTC code again to confirm that the No Intermittent Fault. Refer to Yes Step 11 Diagnostic completed. 5. Repair Instructions: Replace crankshaft position sensor. Refer to Crankshaft Position Sensor Replacement . 2.12.7.36 DTC P0340 P0341 1. DTC Descriptor: DTC P0340 Intake VCP Camshaft Position Sensor Status Diagnosis DTC P0341 Intake VCP Target Wheel Diagnosis Camshaft position (CMP) sensor is used to detect camshaft position, and is associated with the crankshaft position. It sends signals Engine Control Module (ECM) also uses the camshaft position sensor output to determine the camshaft to the crankshaft relative Camshaft position sensor circuit includes the following: – Reference Voltage: ECM provides a reference voltage to CMP sensor harness connector EN15 terminal C via ECM harness – Signal Circuit: ECM receives signal voltage from CMP sensor harness connector EN15 terminal A via ECM harness connector – ECM Low Reference Voltage Circuit: ECM provides a low reference voltage to CMP sensor harness connector EN15 terminal 2. Conditions For Setting DTC and The Fault Location: DTC Code DTC Detection Strategy Conditions For Setting The DTC (Control Strategy) Fault Locations Engine Control System JL4G15-D 2-731 |