Ford GT (2018 year). Manual - part 13

INFORMATION DISPLAY
CONTROL

E227121

See Information Displays (page 70).

DRIVE MODE CONTROL

E227821

See Driving Aids (page 122).

WIPER AND WASHER
CONTROL

E227822

Windshield Washers.

A

Windshield Wipers.

B

See Wipers and Washers (page 57).

LIGHTING CONTROL

E227823

Highbeam control.

A

See Lighting (page 58).

ADJUSTING THE PEDALS

WARNING

Never use the pedal adjustment
controls when your feet are on the
accelerator or brake pedal when the

vehicle is moving.

E227825

You can find the adjustment strap on the
left side of the center console.

Note: Adjust the pedals only when your
vehicle is in P (Park) and the engine is off.

E227824

Note: The brake and accelerator pedals will
move together during the adjustment
procedure.

1.

Position yourself comfortably in the
seat.

2. Pull the pedal adjustment strap to

release the pedal module. The pedals
will automatically move toward the
drivers feet.

3. Place your foot on the foot rest and

move the pedals to a comfortable
position.

4. Release the adjustment strap to lock

the pedals in position. Reinstall the
strap into the recessed pocket after the
adjustment is complete.

5. Test the application of the brake and

accelerator pedals.

6. If needed perform the pedal

adjustment over until the pedals are at
a distance that is both comfortable and
safe to operate.

WINDSHIELD WIPERS

Note: Fully defrost the windshield before
you switch the windshield wipers on.

Note:  If streaks or smears appear on the
windshield, clean the windshield and the
wiper blades.  If that does not resolve the
issue, install new wiper blades.

Note:  Do not operate the wipers on a dry
windshield.  This may scratch the glass,
damage the wiper blades or cause the wiper
motor to burn out.  Always use the
windshield washers before wiping a dry
windshield.

Rotate the knob to switch on the
windshield wipers.

E226966

Off.

O

Intermittent - long interval.

I

Intermittent - short interval.

II

Normal wipe.

III

High-speed wipe.

IIII

WINDSHIELD WASHERS

E226967

Note:  Do not operate the washers when
the washer reservoir is empty.  This may
cause the washer pump to overheat.

Press and hold the button to spray
windshield washer fluid and switch on the
wipers. When you release the button, the
wipers turn on for three additional wipes
and then turn off.

Note: Briefly pressing the washer button
causes a single wipe without washer fluid.

When you use the washers, there is a
courtesy wipe after a short delay to clear
away any drops on the windshield. You can
switch this feature on or off.  See
Information Displays (page 70).