|
|
|
107
Headlamp high beam switch and turn signal lever
Flashing the Lights
To flash the headlamps, pull the lever toward
you for a moment and then release it. The
headlamps will flash whether the headlamp
knob is on or off.
Windshield Wipers and Washer
To turn on the windshield wipers, the ignition
key must be turned to the ON or ACC position.
Turn the knob on the end of the turn signal
lever toward the front of the vehicle. You can
turn it to either the LO or HI speed position.
Variable Interval Wipers
In addition to two speed wipers, your vehicle is
equipped with wipers that you can set to
operate at varying intervals. For example, you
can set the interval so they wipe less often when
it drizzles or more often in heavier rain.
108
Interval wiper on turn signal lever
To set the interval wipers, rotate the knob at the
end of the turn signal lever toward or away
from the instrument panel to the interval
operation you desire.
Windshield Washer
To clean the windshield, push in the end of the
wiper knob. For a constant spray, keep the knob
pushed in. After you release the knob, the
wipers operate for two to three cycles before
turning off (if wipers were off) or returning to
HI, LO, or the interval setting selected.
Do not try to clean the windshield when the
washer fluid container is empty or activate the
washers at any time for more than 15 seconds
continuously. This could damage the washer
pump system.
109
R
WARNING
In freezing weather, the washer solution
may freeze on the windshield and obscure
your vision. Always warm up the
windshield with the defroster before you
use the washer fluid. If you cannot see
through the windshield clearly, it can
increase the risk of being involved in a
collision.
For information about refilling the washer fluid
or replacing your windshield wiper blades, see
Windshield washer fluid and Wipers
in the Index.
Hazard Flasher
The hazard flasher is used to alert other drivers
to hazardous situations.
The flashers will flash and the high-mount
brakelamp will stay on steadily (not flash) with
the brake pedal depressed.
The flashers work whether your vehicle is
running or not. The flashers work for up to two
hours when the battery is fully charged and in
good condition without draining the battery
excessively. If the flashers run for longer than
two hours or if the battery is not fully charged,
the battery can be drained.
To use the hazard flasher:
1.
Push in the flasher button; it will pop out
and the lamps will begin to flash.
2.
To stop the flashers, push in the flasher
button again.
NOTE:
The flasher button will be sticking up
slightly higher when ON than when
OFF.
110
Hazard flasher
Horn
To sound the horn, press either horn pad.
Horn location (with speed control option)
Tilt Steering (If equipped)
R
WARNING
Never adjust the steering wheel when the
vehicle is moving.
|
|
|