|
|
|
102
Turning On the Dome/Map Reading
Lamps (If equipped)
The map lamps are located inside the dome light
assembly, on each side of the dome light. Each
lamp has its own switch.
If you have the Bronco Eddie Bauer, the map
lamps are located in the overhead console. Each
lamp has its own switch.
Map lamps — Eddie Bauer only
Map lamps
103
Cleaning the Instrument Panel Lens
Clean the instrument panel lens with a soft cloth
and a glass cleaner, such as Ford Ultra-Clear
Spray Glass Cleaner, or equivalent. Do not use
paper towel or an abrasive cleaner to clean the
lens as these may cause scratches.
Cleaning the Interior Lamps
Your interior dome lamps and map lamps are
plastic and should be cleaned with a mild
detergent diluted in water. Rinse them with clear
water.
105
Steering Column Controls
The controls on the steering column and wheel
are designed to give you easy access to the
controls while you are driving.
The Turn Signal Lever
You can use the turn signal lever on the left side
of the steering column to:
❑
operate the turn signals and cornering lamps
❑
turn the high beams on/off
❑
flash the lights
❑
turn the windshield wipers and washer
on/off
Turn Signals
Move the lever up to signal a right turn. Move
it down to signal a left turn. The corresponding
indicator light in the instrument cluster will
flash.
If the turn signal stays on after you turn, move
the lever back to the center (off) position.
106
Turn signal lever and functions
If the turn indicator light in the instrument
panel does not illuminate or remains on (doesn’t
flash) when you signal a turn, the turn signaling
system is malfunctioning. Have this condition
corrected as soon as possible, but make sure that
you use the accepted hand signals in the
meantime.
High Beams
To turn on the high beams, turn the headlamp
control knob to the headlamp ON position and
push the turn signal lever away from you until
it latches. When the high beams are ON, the
high beam indicator light on the instrument
panel comes on.
To turn off the high beams, pull the lever
toward you until it latches. The high beam
indicator light turns off.
|
|
|