Ford Bronco (1996 year). Manual - part 14

 

  Index      Ford     Ford Bronco - service manual 1996 year

 

Search            

 

 

 

 

 

 

 

 

 

Content   ..  12  13  14  15   ..

 

 

Ford Bronco (1996 year). Manual - part 14

 

 

54
7.
Grasp belt close to child seat and pull on the
shoulder belt portion of the combination
lap/shoulder belt, then allow the belt to
retract and remove all slack to securely
tighten the child safety seat in the vehicle.
See Figure 5.
55
8.
Before placing the child into the child seat,
forcibly tilt the child seat from side-to-side
and in forward directions to make sure that
the seat is held securely in place. See Figures
6 and 7. If the child seat moves excessively,
repeat steps 6 through 8, or properly install
the child seat in a different seating position.
56
9.
Check from time to time to be sure that
there is no slack in the lap/shoulder belt.
The shoulder belt must be snug to keep the
lap belt tight during a collision.
57
Attaching Safety Seats With Tether Straps
General Instructions
Some manufacturers make safety seats that
include an upper tether strap that goes over the
seatback and attaches to an anchoring point.
Other manufacturers offer the tether strap as an
accessory. Contact the manufacturer of your
child safety seat for information about ordering
a tether strap.
You can attach a tether strap anchor bracket to
the rear floor by using a tether anchor kit
(613D74), available at no charge from any Ford
dealership.
Read and follow the instructions provided with
the kit carefully for installation of the child
tether strap anchor.
Follow the child seat manufacturer’s instructions
to attach the tether strap to the tether bracket.
Ford recommends placement of tethered safety
seats in a rear seating position with the tether
strap installed to the tether anchoring point as
shown in the instructions provided with the
child tether strap anchor kit.
This vehicle has provisions to install a tether
anchorage in the front, right hand and all second
row seating positions. It is easiest to install a
tether anchor at the second row, rear, center
seating position.
If the tethered seat is installed in the front seat,
Ford recommends the center front seating
position, with the tether strap secured to the
center rear lap belt tongue or to the webbing of
the buckled center rear lap belt behind the child
safety seat. The front, right hand seating position
may be used if it is the only seating position
available.

 

 

 

 

 

 

 

Content   ..  12  13  14  15   ..