|
|
|
46
7.
Before placing the child in the child seat,
forcibly tilt the seat from side to side, and
tug it forward to make sure that the seat is
securely held in place, Figure 7.
Checking that the seat is secure
47
8.
Double check that the retractor is in the
automatic locking mode. Try to pull more
belt out of the retractor. If you cannot, the
belt is in the automatic locking mode,
Figure 8.
Checking the retractor
9.
Check to make sure that the child seat is
properly secured prior to each use. If the
retractor is not locked, repeat steps 4
through 7.
To remove the retractor from automatic lock
mode, allow webbing to retract fully to its
stowed position and the retractor will
automatically switch back to the vehicle sensitive
locking mode for normal adult usage.
48
Installing a Child Safety Seat at the Rear
Center Seating Position with Locking
Adjustable Lap Belt
1.
Lengthen the lap belt. To lengthen the belt,
hold the tongue so that its bottom is
perpendicular to the direction of webbing
while sliding the tongue up the webbing.
2.
Place the child safety seat in the center
seating position.
3.
Route the tongue and webbing through the
child seat according to the child seat
manufacturer’s instructions.
4.
Insert the belt tongue into the proper buckle
for the center seating position until you hear
a snap and feel it latch. Make sure the
tongue is securely fastened to the buckle by
pulling on tongue.
5.
Push down on the child seat while pulling
on the loose end of the lap belt webbing to
tighten the belt.
6.
Before placing the child into child seat,
forcibly tilt the child seat from side-to-side
and in forward directions to ensure that the
seat is held securely in place. If the child
seat moves excessively, repeat steps 5
through 6, or properly install the child seat
in a different seating position.
49
Installing Child Safety Seats at the Rear
Outboard Seating Positions (For lap and
shoulder belts combination with “cinch
tongues”)
Your vehicle is equipped with rear seat safety
belts containing a “cinch tongue.” The rear
outboard safety belts will have the following
label:
|
|
|