|
|
P1572-BRAKE PEDAL STUCK ON (CONTINUED) 5. (V32) BRAKE SWITCH NO.2 SIGNAL CIRCUIT OPEN Measure the resistance of the (V32) Brake Switch No.2 Signal circuit Is the resistance below 5.0 ohms? Yes >> Go To 6 No >> Repair the open in the (L50) Brake Lamp Switch Output circuit. Perform the POWERTRAIN VERIFICATION TEST. (Refer 6. PCM NOTE: Before continuing, check the PCM harness connector terminals for corrosion, damage, or terminal Were there any problems found? Yes >> Repair as necessary. Perform the POWERTRAIN VERIFICATION TEST. (Refer to 9 - ENGINE - STANDARD PROCEDURE) No >> Replace and program the Powertrain Control Module per Service Information. Perform the POWERTRAIN VERIFICATION TEST. (Refer to 9 - ENGINE - STANDARD PROCEDURE) 9 - 758 ENGINE - ELECTRICAL DIAGNOSTICS - 3.7L/4.7L/5.7L DR/DH |