|
|
APS RELAY CONTROL CIRCUIT LOW (CONTINUED) 3. ADJUSTABLE PEDALS RELAY CONTROL CIRCUIT SHORTED TO GROUND Turn the ignition off. Remove the FCM from the IPM. Remove the Adjustable Pedals Relay. Turn the ignition on. Measure the resistance between ground and the Adjustable Pedals Relay Control circuit in the Adjustable Pedals Is the resistance below 100 ohms? Yes >> Repair the short to ground in the Adjustable Pedals Relay Control circuit. Perform APS VERIFICATION TEST - VER 1. (Refer to 5 - BRAKES/ELECTRICAL - DIAGNOSIS AND No >> Replace the FCM in accordance with the Service Information Perform APS VERIFICATION TEST - VER 1. (Refer to 5 - BRAKES/ELECTRICAL - DIAGNOSIS AND 4. INTERMITTENT DTC Turn the ignition off. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors. Check connectors - Clean/repair as necessary. Refer to any Technical Service Bulletins that may apply. Were any problems found? Yes >> Repair as necessary. Perform APS VERIFICATION TEST - VER 1. (Refer to 5 - BRAKES/ELECTRICAL - DIAGNOSIS AND No >> Test Complete. 5 - 196 BRAKES - ABS - ELECTRICAL DIAGNOSTICS DR/DH |