|
|
Content .. 1026 1027 1028 1029 ..
*NO RESPONSE WITH A NO START CONDITION (CONTINUED) 8. (F856) 5-VOLT SUPPLY CIRCUIT SHORTED TO GROUND Disconnect all the sensors that share the (F856) 5-volt Supply circuit. Measure the resistance between ground and the (F856) 5-volt Supply circuit at one of the sensor harness connec- Is the resistance below 100 ohms? Yes >> Repair the short to ground in the (F856) 5-volt Supply circuit. Perform the POWERTRAIN VERIFICATION TEST. (Refer to 9 - ENGINE - STANDARD PROCEDURE) No >> Go To 9 9. PCM NOTE: Before continuing, check the PCM harness connector terminals for corrosion, damage, or terminal Were there any problems found? Yes >> Repair as necessary. Perform the POWERTRAIN VERIFICATION TEST. (Refer to 9 - ENGINE - STANDARD PROCEDURE) No >> Replace and program the Powertrain Control Module per Service Information. Perform the POWERTRAIN VERIFICATION TEST. (Refer to 9 - ENGINE - STANDARD PROCEDURE) 9 - 1034 ENGINE - ELECTRICAL DIAGNOSTICS - 3.7L/4.7L/5.7L DR/DH |