|
|
3. Push and hold the Homelink button you want to program while you push and hold the hand-held trans- 4. Continue to hold both buttons and observe the indicator light. The Homelink indicator will flash slowly and then 5. Push and hold the programmed HomeLink button and observe the indicator light. • If the indicator light stays on constantly, programming is complete and the garage door/device should acti- • To program the two remaining HomeLink buttons, repeat each step for each remaining button. DO NOT Reprogramming A Single HomeLink Button To reprogram a channel that has been previously trained, 1. Cycle the ignition to the ON/RUN position. 2. Push and hold the desired HomeLink button until the indicator light begins to flash after 20 seconds. Do not 3. Without releasing the button, proceed with “Program- ming A Non-Rolling Code” step 2 and follow all remain- Canadian/Gate Operator Programming For programming transmitters in Canada/United States Canadian radio frequency laws require transmitter signals It may be helpful to unplug the device during the cycling 1. Cycle the ignition to the ON/RUN position. 3 UNDERSTANDING THE FEATURES OF YOUR VEHICLE 217 |