Chery A15. Manual - part 219

Chery A15 Maintenance Manual

4. Speed Sensors

Possible Cause

4. Fault Code 00283, 00285, 00290, 00287
[Description]
This code will be displayed when open circuit or short
circuit of sensor is detected.
[Tip]
The fault may be caused by poor contact of sensor, short
circuit of sensor coil or wire harness, or problem with
sensor signal processing circuit in ABS ECU.

Large or medium open circuit of

sensor adapter

Short circuit of sensor circuit

Short circuit of sensor plug or wire

harness with earthproof or power

ABS ECU sensor signal

processing circuit fault

Check each wheel sensor

Normal

Abnormal

Normal

Yes

Check wire harness between

sensor and ABS ECU

Normal

Replace ABS ECU

Demount ABS ECU plug
and check the resistance
between following
terminals.

Standard value:1.0-1.3kΩ

Shake sensor wire harness
and adapter when
measuring resistance.

MK20I/E

Front left: 1-2

Front right: 19-20

Rear left: 5-6

Rear right: 22-23

Check corresponding

sensor adapter

Dose the fault reoccur?

Refer to

Incidental Fault

Repair

Instruction

Repair adapter

Chery A15 Maintenance Manual

5. ABS Coding Error

Possible Cause

5. Fault Code 01044
[Description]
This code will be displayed when inconsistency
between software coding of ECU and hardware
connection of ABS wire harness is detected.

Wrong connection of plunger

pin in ABS wire harness

ABS ECU coding error

Recode

Check if software coding of ABS ECU is
correct with fault diagnoser
Correct value: refer to related ABS
electrical wiring diagram

Abnormal

Repair wire harness

Check plunger pin conduction in ABS wire
harness
Plunger pin connecter: refer to related ABS
electrical wiring diagram

Chery A15 Maintenance Manual

6. Power Terminal 30

Possible Cause

6. Fault Code 00668
[Description]
This code will be displayed when power terminal 30
supplies power or overvoltage is detected.

ABS system fuse burned

Battery overvoltage or undervoltage

ABS wire harness adapter damage

ABS ECU damage

Abnormal
Check ABS system 30 fuse Replace fuse

Normal

Abnormal Abnormal

                                  Check ABS wire harness                    Repair adapter
                                              adapter

Normal

Recheck. Dose abnormity reoccur? No Refer to Incidental
                                                                                                                                Fault Repair Instruction
                                                                                                    Yes
                                                                              Check battery voltage

Normal

Measure voltage between
following terminals with ABS
wire harness disconnected to
ECU and ignition switch being
“ON”.
Terminal 8 and 9: 9.5-16.5V
Terminal 24 and 25: 9.5-16.5V
MK20I/E:
Terminal 8 and 4: 9.5-16.5V

Replace ABS ECU

Chery A15 Maintenance Manual

7. ABS Malfunction

Possible Cause

7 Fault Code 01130
[Description]
This code will be displayed when ABS is interfered by
high frequency electromagnetic wave or microprocessor
takes speed signal input as unreliable

Interference of high frequency

electromagnetic wave

Sensor or sensor wire harness

damage

ABS ECU damage

Abnormal Abnormal

Check sensor output voltage Check sensor Replace sensor

Normal Normal

Replace ABS ECU Check wire harness

between ECU and sensor

Content .. 217 218 219 220 ..