Kia Sedona (2008 year). Manual - part 453

Fig. 65: Identifying Bead Of Adhesive Around Edge Of Windshield Between Fastener And Molding
Courtesy of KIA MOTORS AMERICA, INC. 

9. Use suction cups (A) to hold the windshield over the opening, align it with the alignment marks (B) made 

in step 15, and set it down on the adhesive. Lightly push on the windshield until its edges are fully seated 
on the adhesive all the way around. Do not open or close the doors until the adhesive is dry. 

Fig. 66: Aligning Windshield With Alignment Marks 
Courtesy of KIA MOTORS AMERICA, INC. 

10. Scrape or wipe the excess adhesive off with a putty knife or towel. To remove adhesive from a painted 

surface or the windshield, wipe with a soft shop towel dampened with alcohol.  

 

2008 Kia Sedona EX 

2008 ACCESSORIES & BODY, CAB Interior - Sedona

  

Microsoft 

 

Monday, May 24, 2010 4:05:49 PM

Page 47 

© 2006 Mitchell Repair Information Company, LLC. 

11. Let the adhesive dry for at least one hour, then spray water over the windshield and check for leaks. Make 

leaking areas, and let the windshield dry, then seal with sealant: 



Let the vehicle stand for at least four hours after windshield installation. If the vehicle has to be 
used within the first four, it must be driven slowly.  



Keep the windshield dry for the first hour after installation.  

12. Reinstall all remaining removed parts. Install the rearview mirror after the adhesive has dried thoroughly. 

Advise the customer not to do the following things for two the three days: 



Slam the door with all the windows rolled up.  



Twist the body excessively (such as when going in and out of driveways at an angle or driving over 
rough, uneven roads)  

QUARTER GLASS REPLACEMENT 

1. Remove the antenna cable (A). 

Fig. 67: Identifying Antenna Cable 
Courtesy of KIA MOTORS AMERICA, INC. 

2. Remove the rear pillar trim.  

3. Loosen the mounting screw. 

 

2008 Kia Sedona EX 

2008 ACCESSORIES & BODY, CAB Interior - Sedona

  

Microsoft 

 

Monday, May 24, 2010 4:05:49 PM

Page 48 

© 2006 Mitchell Repair Information Company, LLC. 

Fig. 68: Identifying Mounting Screw 
Courtesy of KIA MOTORS AMERICA, INC. 

4. After loosening the quarter glass mounting bolts, then remove the quarter glass (A). 

Fig. 69: Identifying Quarter Glass And Bolts 
Courtesy of KIA MOTORS AMERICA, INC. 

5. Installation is the reverse of removal. 

 

2008 Kia Sedona EX 

2008 ACCESSORIES & BODY, CAB Interior - Sedona

  

Microsoft 

 

Monday, May 24, 2010 4:05:49 PM

Page 49 

© 2006 Mitchell Repair Information Company, LLC. 

2008 ACCESSORIES & BODY, CAB

Keyless Entry & Burglar Alarm - Sedona 

COMPONENT LOCATION 

Fig. 1: Keyless Entry And Burglar Alarm Component Locations 
Courtesy of KIA MOTORS AMERICA, INC. 

DESCRIPTION 

 

2008 Kia Sedona EX 

2008 ACCESSORIES & BODY, CAB Keyless Entry & Burglar Alarm - Sedona

  

 

2008 Kia Sedona EX 

2008 ACCESSORIES & BODY, CAB Keyless Entry & Burglar Alarm - Sedona

  

Microsoft 

 

Monday, May 24, 2010 4:17:42 PM

Page 1 

© 2006 Mitchell Repair Information Company, LLC. 

Microsoft 

 

Monday, May 24, 2010 4:17:46 PM

Page 1 

© 2006 Mitchell Repair Information Company, LLC.