Model MA TOW Tractor. Manual - part 12

Chapter 1: General Information and Operating Instructions   Dec. 1995           Section 1-5                     p. 1

V.

STORAGE

A.

FOR ONE MONTH

l.

Engine

(a)

Gasoline

(1)

Run the engine at 1500 RPM and treat the upper cylinder by spraying an
engine preservative oil into the carburetor air intake for about two minutes.
This oil should be SAE #10, formulated for antirust and anticorrosion
protection, along with being a high detergent type that meets requirements for
most severs (M.S.) service and also Ford Specification M-2C35.  Open throttle
for a short burst of speed, then shut off the ignition and allow the engine to
come to a stop while continuing to spray the oil into the carburetor air intake.

(2)

Leave the spark plugs installed and cover all engine openings with dust-proof
caps or shields.

(3)

Drain oil from crank case.

(4)

Drain water from radiator and engine block.

(5)

Drain fuel from tank, carburetor and fuel lines, (Gasoline only).

(6)

Attach a CAUTION tag on steering wheel stating: Oil and water has been
removed from engine.

(b)

Diesel

(1)

Run the engine until it reaches normal operating temperature and then shut
the engine down.

(2)

Drain oil from crank case and refill with required amount.

CAUTION: OIL WILL BE HOT.

(3)

Drain water from radiator and engine block.

(4)

Attach a CAUTION tag on steering wheel stating: water has been removed
from engine.

2.

Transmission

No special attention needed.

3.

Axle and Reduction Gear Box

No special attention needed.

Chapter 1: General Information and Operating Instructions   Dec. 1995           Section 1-5                     p. 2

V.

STORAGE

A.

FOR ONE MONTH (CONT)

4.

Tires

The tractor should be raised and axles chocked to prevent tire contact with ground.  The
pressure should be reduced to 15 P.S.I.

5.

Lubrication

Ensure that all points are lubricated with specified grease, oil, etc.

6.

Fluid Levels

All fluid levels should be checked and topped off as necessary.

7.

Wheel Bearings

Wheel bearings should be repacked.

8.

Battery

Disconnect battery terminals.

B.

INDEFINITE PERIOD

1.

Engine

(a)

Gasoline

(1)

Run the engine at 1500 RPM and treat the upper cylinder by spraying an
engine preservative oil into the carburetor air intake for about two minutes.
This oil should be SAE #10, formulated for antirust and anticorrosion
protection, along with being a high detergent type that meets requirements for
most severs (M.S.) service and also Ford Specification M-2C35.  Open throttle
for a short burst of speed, then shut off the ignition and allow the engine to
come to a stop while continuing to spray the oil into the carburetor air intake.

(2)

Leave the spark plugs installed and cover all engine openings with dust-proof
caps or shields.

(3)

Drain oil from crank case.

(4)

Drain water from radiator and engine block.

Chapter 1: General Information and Operating Instructions   Dec. 1995           Section 1-5                     p. 3

(5)

Drain fuel from tank, carburetor and fuel lines, (Gasoline only).

(6)

Attach a CAUTION tag on steering wheel stating: Oil and water has been
removed from engine.

(b)

Diesel

(1)

Run the engine until it reaches normal operating temperature and then shut
the engine down.

(2)

Drain oil from crank case and refill with required amount.

CAUTION: OIL WILL BE HOT.

(3)

Drain water from radiator and engine block.

(4)

Attach a CAUTION tag on steering wheel stating: water has been removed
from engine.

2.

Transmission

(a)

Drain transmission fluid.

(b)

Refill transmission.

NOTE:  Prolonged storage may be detrimental to the seals in the transmission.

3.

Axle and Reduction Gear Box

Drain drive axle and reduction gear box by removing drain plug located on the underside
of the differential carrier housing.  Reinstall plug after draining.  The drive axle and
reduction gear box are connected internally and share the same oil.

Attach a CAUTION tag on steering wheel stating: Oil has been removed from axle and
reduction gear box.

4.

Tires

The tractor should be raised and axles chocked to prevent tire contact with the ground.

Tire pressure should be reduced to 15 P.S.I., and sprayed with a rubber preservative.

5.

Ensure that all points are lubricated with specified grease, oil, etc.

Chapter 1: General Information and Operating Instructions   Dec. 1995           Section 1-5                     p. 4

V.

STORAGE

B.

INDEFINITE PERIOD (CONT)

6.

Levels

All fluid levels should be checked and topped off as necessary.

7.

Wheel Bearings

Wheel bearings should be repacked.

8.

Battery

The battery should be removed and stored separately.  The battery must be stored in a
cool dry place and must not be exposed to direct sunlight.  A recommended storeroom
temperature of 32 F (0 C) to 90 F (32 C) should be maintained.  If the battery is stored in
the open, it must be covered for protection against dirt and moisture.  A slow charge
should be given to the battery every one to two months.