Polaris ACE 570 (2018 year). Manual - part 14

60

OPERATION

Turning the Vehicle

Your vehicle is equipped with a 

solid rear axle, which drives both 

rear wheels equally at all times. 

This means that the wheel on the 

outside of the turn must travel a 

greater distance than the inside 

wheel when turning and the inside 

tire must slip traction slightly.
To turn the vehicle, rotate the 

steering wheel in the direction of 

the turn.
Practice making turns at slow 

speeds before attempting to turn at 

faster speeds.

WARNING! Turning improperly can 

result in vehicle rollover. Never turn 

abruptly or at sharp angles. Never turn 

at high speeds.

61

OPERATION

Driving on Slippery Surfaces

When driving on slippery surfaces such as wet trails, loose gravel, or 

ice, be alert for the possibility of skidding and sliding. Follow these 

precautions when encountering slippery conditions:
1. Do not operate on excessively rough, slippery or loose terrain.
2. Slow down before entering slippery areas.
3. Maintain a high level of alertness, reading the trail and avoiding 

quick, sharp turns, which can cause skids.

4. Engage all-wheel drive before wheels begin to lose traction.

NOTICE: Severe damage to the drive train may occur if the AWD is engaged 

while the wheels are spinning. Always allow the wheels to stop 

spinning before engaging AWD.

5. Correct a skid by turning the steering wheel in the direction of the 

skid. Never apply the brakes during a skid.

Sideways 

skid

Turn in 

direction of 

skid

62

OPERATION

Driving Uphill

Whenever traveling uphill, follow these precautions:
1. Always check the terrain carefully before ascending any hill. Never 

drive on hills with excessively slippery or loose surfaces.

2. Never operate in TURF mode (if equipped) while operating on a hill 

or other irregular terrain. Always move the AWD switch to AWD 

before ascending or descending a hill.

3. Avoid excessively steep hills. If ascending a steeper grade is 

unavoidable, engage all-wheel drive before ascending.

4. Drive straight uphill.
5. Proceed at a steady rate of speed and throttle opening. Never open 

the throttle suddenly. 

6. Avoid unnecessary changes in speed or direction. 
7. Never go over the crest of a hill at high speed. An obstacle, a sharp 

drop, or another vehicle or person could be on the other side of the 

hill.

8. If the vehicle stalls while climbing a hill, apply the brakes. Place the 

transmission in reverse and slowly allow the vehicle to roll straight 

downhill while applying light brake pressure to control speed.

63

OPERATION

Driving on a Sidehill (Sidehilling)

Driving on a sidehill is not recommended. Improper procedure could 

cause loss of control or rollover. Avoid crossing the side of any hill 

unless absolutely necessary.
If crossing a hill is unavoidable, follow these precautions:
1. Engage all-wheel drive.
2. Never operate in TURF mode (if equipped) while operating on a hill 

or other irregular terrain. Always move the AWD switch to AWD 

before ascending or descending a hill.

3. Drive slowly and use extreme caution.
4. If the vehicle begins to overturn, or if it feels as if it may overturn, 

immediately turn downhill.

5. Avoid obstacles and changes in terrain that may lower or raise one 

side of the vehicle or cause the vehicle to slide.

6. If the vehicle begins to slide downhill, immediately turn downhill to 

stop the slide, or stop the vehicle and maneuver slowly and 

carefully until the vehicle can be driven straight downhill.