Content .. 10 11 12 13 ..

Polaris ACE 570 (2018 year). Manual - part 12

OPERATION

Failure to operate the vehicle properly can result in a collision, loss of control,

accident or rollover, which may result in serious injury or death. Read and

understand all safety warnings outlined in the safety section of this owner’s

manual.

Vehicle Break-in Period

The break-in period for your new POLARIS vehicle is the first 25 hours

of operation, or the time it takes to use the first two tanks full of

gasoline. No single action on your part is as important as a proper break-

in period. Careful treatment of a new engine and drive components will

result in more efficient performance and longer life for these

components. Perform the following procedures carefully.

NOTICE: Excessive heat build-up during the first three hours of operation will

damage close-fitted engine parts and drive components. Do not

operate at full throttle or high speeds during the first three hours of

use.
Use of any oils other than those recommended by POLARIS may

cause serious engine damage. We recommend the use of POLARIS

PS-4 Full Synthetic 5W-50 4-Cycle Oil for your 4-cycle engine.

WARNING

OPERATION

Vehicle Break-in Period

Engine and Drivetrain Break-in

1. Fill the fuel tank with gasoline. See page 29. Always exercise

extreme caution whenever handling gasoline.

2. Check the oil level. See page 92. Add the recommended oil as

needed to maintain the oil level in the safe operating range.

3. Complete the New Operator Driving Procedures outlined on pages

58-59.

4. Avoid aggressive use of the brakes.
5. Vary throttle positions. Do not operate at sustained idle.
6. Pull only light loads.
7. Perform regular checks on fluid levels, controls and areas outlined

on the daily pre-ride inspection checklist. See page 54.

8. During the break-in period, change both the oil and the filter at 25

hours or one month.

9. Check fluid levels of transmission and all gearcases after the first 25

hours of operation and every 100 hours thereafter.

Brake System Break-in

Apply only moderate braking force for the first 50 stops. Aggressive or

overly forceful braking when the brake system is new could damage

brake pads and rotors.

PVT Break-in (Clutches/Belt)

A proper break-in of the clutches and drive belt will ensure a longer life

and better performance. Break in the clutches and belt by operating at

slower speeds during the break-in period as recommended. Pull only

light loads. Avoid aggressive acceleration and high speed operation

during the break-in period.
If a belt fails, always clean any debris from the PVT intake and outlet

duct and from the clutch and engine compartments when replacing the

belt.

OPERATION

Pre-Ride Inspection

Failure to inspect and verify that the vehicle is in safe operating

condition before operating increases the risk of an accident. Always

inspect the vehicle before each use to make sure it's in safe operating

condition.

Item

Remarks

Page

Brake system/pedal travel

Ensure proper operation

35, 111

Brake fluid

Ensure proper level

112

Front suspension

Inspect, lubricate if necessary

Rear suspension

Inspect, lubricate if necessary

Steering/Steering Lock

Unlock the steering; Ensure free

operation

114

Tires

Inspect condition and pressure

13, 115

Wheels/fasteners

Inspect, ensure fastener tightness

115

Frame nuts, bolts,

fasteners

Inspect, ensure tightness

Fuel and oil

Ensure proper levels

41, 92

Coolant level

Ensure proper level

103-104

Coolant hoses

Inspect for leaks

Throttle

Ensure proper operation

111

Indicator lights/switches

Ensure proper operation

Air filter, pre-filter

Inspect, clean

108-109

Intake pre-filters

Inspect, clean

109

Headlamps

Check operation, apply POLARIS

dielectric grease when lamp is

replaced

117

Turn Signals

Ensure operation of all signal lamps

Mirrors

Adjust for best side/rear vision

Horn

Ensure operation

Brake light/tail lamps

Check operation, apply POLARIS

dielectric grease when lamp is

replaced

117

Riding gear

Wear approved helmet, goggles,

and protective clothing

Seat Latch

Push down on the seat back to

ensure the latch is secure

Seat Belt

Check length of belt for damage,

check latches for proper operation

Cab Nets

Check for wear or damage, ensure

proper installation

OPERATION

Safe Operation Practices

1. POLARIS strongly encourages you and any family members who

will be riding this vehicle to take a training course.

2. Do not allow anyone under 16 years of age or without a valid

driver’s license to operate this vehicle.

3. Never carry a passenger on this vehicle.
4. Engine exhaust fumes are poisonous. Never start the engine or let it

run in an enclosed area.

5. Never operate with accessories not approved by POLARIS for use

on this vehicle.

6. Use caution and drive at reduced speeds in conditions of reduced

visibility such as fog, rain and darkness. Clean headlights

frequently and replace burned out headlamps promptly.

7. Always operate at a speed that's appropriate for the terrain, the

visibility and operating conditions and your skills and experience.

Never operate at excessive speeds. Never attempt wheelies, jumps,

or other stunts. Keep both hands on the steering wheel during

operation.

8. Never consume alcohol or drugs before or while operating this

vehicle.

9. Always use the size and type of tires specified for your vehicle.

Always maintain proper tire pressure.

10. Never operate a damaged vehicle. After any rollover or accident,

have a qualified service dealer inspect the entire machine for

possible damage.

11. Never operate the vehicle on a frozen body of water unless you have

first verified that the ice is sufficiently thick to support the weight

and moving force of the vehicle, you and your cargo, together with

any other vehicles in your party.

12. Do not touch hot exhaust system components. Always keep

combustible materials away from the exhaust system.

13. Always remove the ignition key when the vehicle is not in use to

prevent unauthorized use.

Content .. 10 11 12 13 ..