Snowmobile Polaris 600 Switchback / 800 Switchback (2013 year). Manual - part 7

 

  Index      Snowmobiles / ATV     Snowmobile Polaris 600 Switchback, 600 Switchback Pro-R, 600 Switchback Adventure, 800 Switchback, 800 Switchback Pro-R, 800 Switchback Pro-R Adventure - service manual 2013 year

 

Search            

 

 

 

 

 

 

 

 

 

Content   ..  5  6  7  8   ..

 

 

Snowmobile Polaris 600 Switchback / 800 Switchback (2013 year). Manual - part 7

 

 

28

FEATURES

Detonation Elimination Technology (DET)

The DET system prevents damage to the engine from detonation by 
going into an engine protection mode whenever the DET system is 
active.

When excessive detonation is detected, 
the check engine light will illuminate 
and you may notice decreased engine 
performance and RPM when the DET 
system is activated. In most cases this 
is temporary and the operator does not 
need to take any action. The engine 
will return to its normal performance 
automatically.

If severe detonation occurs, the check engine light will begin to flash 
steadily and the gauge indicator will read “dET” (see illustration). The 
engine will enter a limp home mode and RPM will be limited to 6500 
RPM. The engine will remain in this mode until it is shut down and 
restarted.

Check Engine Light

Indicates

Solid or Flickering

Excessive detonation detected

Steady Flashing

Severe detonation detected, RPM will be limited

29

FEATURES

Detonation Elimination Technology (DET)

The most likely causes of severe detonation are outlined in the trouble-
shooting table below.
DET Troubleshooting

Security System (Ignition Lock System)

Your snowmobile has an optional security function that can be activated 
by an authorized POLARIS dealer. If you have this feature activated, 
you can lock the ignition to prevent unauthorized use when leaving the 
snowmobile unattended. A locked system will limit engine speed to 
3000 RPM, which prevents clutch engagement, and the snowmobile 
will not move when throttle is applied.

If you wish to use this system, see page 37 of the Instrument Cluster 
section for security system activation and operating instructions.

Cause of DET Activation

Solution

Poor quality fuel

Replace with higher quality fuel

Incorrect ethanol/non-ethanol fuel 

type setting

Verify correct fuel type setting on 

gauge

Low fuel/no fuel in tank

Refuel with recommended fuel

Water in fuel

Replace with recommended fuel

Plugged fuel filter or tank pick-up sock See your POLARIS dealer for service

Alcohol-based fuel additive used with 

Ethanol fuel

Do not add deicers or additives that 
contain any form of alcohol while 
using up to 10% ethanol fuel

Improper engine modifications

Do not modify the engine

30

FEATURES

Instrument Cluster

The instrument cluster contains 
indicator lights and the rider 
information center. The information 
center can be controlled by either 
the MODE and SELECT buttons on 
the instrument cluster or by the 
MODE/SET switch on the left 
handlebar.

NOTICE: Certain products will damage 

the lens and other plastic sur-
faces. Do not use alcohol to 
clean the instrument cluster. 
Immediately clean off any 
gasoline that splashes on the 
instrument cluster.

Rider Information 

Center

Check Engine 

Indicator

High Beam 

Indicator

Low Oil 

Indicator

Over-

Temperature 

Indicator

Park Brake

Indicator

Reverse 

Indicator

MODE

Button

SELECT

Button

Mode/Set 

Switch

SET

MOD

E

31

FEATURES

Instrument Cluster

Indicators

Check Engine Indicator

This indicator appears if an EFI-related fault occurs. Do not operate the 
snowmobile if this warning appears. Serious engine damage could 
result. See your dealer. See page 44 for diagnostic code definitions.

Over-Temperature Indicator

This indicator illuminates to alert the operator that the engine is over-
heating. The operator should take action to cool the engine. See page 92. 
If the indicator flashes, continued operation could result in serious 
engine damage. Stop the engine immediately.

Low Oil Indicator

The low oil indicator light may flicker at times due to oil movement in 
the bottle, but when the light comes on and remains on, add the recom-
mended oil before further operation. See page 73.

High Beam Indicator

The high beam indicator illuminates when the lights are set to high 
beam.

Parking Brake Indicator

This indicator illuminates when the parking brake is engaged. It will 
also illuminate when the service brake is in use. See page 64.

Reverse Indicator

This indicator flashes when the snowmobile is in reverse. See page 78.

 

 

 

 

 

 

 

Content   ..  5  6  7  8   ..