|
|
-94- CVT System There may be some instances when water is accidently ingested into the
CVT system. Use the following ins- tructions to dry it out before operating. .
Remove the seats. See page 34. 2 .
Loosen the lower screws that secure the clutch cover. 3 .
Allow the water to drain. 4.
Tighten the screws.
5 .
Place the transmission in PARK. Apply the brakes. 6 .
Start the engine. 7 .
Apply varying throttle for 10-15 seconds to expel the moisture and air-dry the belt and clutches.
Do not hold the throttle wide open for
more than 10 seconds.
8 .
Allow the engine RPM to settle to idle speed.
Apply the brakes.
Shift the transmission to the lowest avai- lable range. .
Test for belt slippage. If the belt slips, repeat the process. 10 .
Take the vehicle to your dealer for service as soon as possible. |