|
|
Content .. 1480 1481 1482 1483 ..
Fig. 15: Vehicle Speed Driving Pattern a. Preconditions The monitor will not run unless: The MIL is OFF. b. Drive Pattern 1. Connect the Techstream to the DLC3. 2. Turn the ignition switch to ON. 3. Turn the Techstream ON. 4. Clear DTCs (if set) (see DTC CHECK/CLEAR ). 5. Start the engine. 6. Allow the engine to idle for 10 minutes or more. 7. Drive the vehicle at 40 km/h (25 mph) or more for at least 2 minutes. c. Monitor Status 1. Check the Readiness Monitor status displayed on the Techstream. If the status does not switch to complete, make sure that the preconditions have been met, PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are Inspect the fuses and relays related to this system before inspecting the suspected areas below. SFI SYSTEM PROBLEM SYMPTOM CHART Symptom Suspected Area Refer To Engine does not crank (Does not Battery ON-VEHICLE INSPECTION Starter INSPECTION Starter relay STARTER RELAY Cranking Holding Function CRANKING HOLDING Park/neutral position switch INSPECTION Immobilizer system HOW TO PROCEED WITH
2009 Toyota Tundra 2009 ENGINE PERFORMANCE Engine Control System (3UR-FBE) - Tundra
|