|
|
4F-44 Electronic Stability Program: Repair Instructions Hydraulic Unit Operation Check S6JB0A4606001 Refer to “Hydraulic Unit Operation Check in Section 4E”. Sensor Calibration S6JB0A4606002 CAUTION !
If any DTC(s) other than C1075, C1076, C1077
NOTE ® control module and/or yaw rate / G sensor assembly is removed, sensor
Sensor Calibration (Using SUZUKI Scan Tool) 1) Set steering wheel in straight-ahead position. (DLC) (1) with ignition switch OFF. Special tool 6 CAN communication circuit check communicating by means of CAN. Is each CAN communication circuit between disconnected ® control module and BCM) opened, shorted or high resistance? Go to Step 7. Repair or replace the 7 DTC check for ESP ® 1) Connect connectors of disconnected control modules communicating by means of CAN. 2) Disconnect each connector. • ECM 3) Check DTC for ESP ®. Is DTC U1140 detected? Check ESP ® control module power and ® hydraulic unit / control Check applicable Step Action Yes No (A) 1 I5JB0A450008-01 |