|
|
Content .. 1288 1289 1290 1291 ..
ID REGISTRATION CANNOT BE COMPLETED WT-39 < SYMPTOM DIAGNOSIS > C D F G H I J K L M A B WT N O P ID REGISTRATION CANNOT BE COMPLETED Description INFOID:0000000010120205 The ID of the tire pressure sensor installed in each wheel cannot be registered in the tire pressure monitoring system. Inspect the tire pressure sensor or the tire pressure monitoring system circuit. Diagnosis Procedure INFOID:0000000010120206 1. CHECK TIRE PRESSURE SENSOR ACTIVATION TOOL Check tire pressure sensor activation tool. YES >> GO TO 2. NO >> Replace the battery of tire pressure sensor activation tool or repair/replace the tire pressure sen- sor activation tool. 2. TIRE PRESSURE SENSOR ID REGISTRATION Perform tire pressure sensor ID registration. Refer to . CAUTION: To perform ID registration, observe the following points: • Never register ID in a place where radio waves are interfered (e.g. radio tower). • Never register ID in a place close to vehicles including TPMS. YES >> Inspection End. NO >> GO TO 3. 3. CHECK TIRE PRESSURE SIGNAL Change the work location and perform ID registration again. NOTE: Depending on the tire pressure sensor position*, a blind spot exists, and the remote keyless entry receiver gets poor reception. If an ID registration is performed under this condition, the registration may not be com- pleted. In such case, follow the instructions below to improve the radio wave receiving environment. • Rotate tire by 90 °, 180°, or 270°. (This Step is to change tire pressure sensor position.) • Open the door close to the tire of which ID registration is ongoing. *: Radio wave reception condition depends on vehicle architecture (e.g. body harness layout, tire wheel design) or environment. All wheels react and ID registration is possible.>>Inspection End. Only certain wheel(s) do not react.>>Replace applicable tire pressure sensor. Refer to All wheels do not react.>>Check the remote keyless entry receiver. Refer to |