|
|
SPECIFICATIONS TSB Revision POWER STEERING 37A-47 SERVICE SPECIFICATIONS M1372000300052 LUBRICANTS M1372000400059 ITEMS STANDARD VALUE LIMIT Steering wheel free With engine running − 30 (1.2) With engine stopped 10 (0.4) or less − Steering angle Inside wheel 2.4L ENGINE 36 ° 36' ± 2 ° 00' − 3.0L ENGINE 33 ° 06' ± 2 ° 00' − Outside wheel (reference) 2.4L ENGINE 30 ° 42' − 3.0L ENGINE 28 ° 30' − Tie rod end ball joint breakaway torque N ⋅ m (in-lb) 0.5 − 2.5 (4.4 − 22.1) − Tie rod swing resistance N (lb) [N ⋅ m (in-lb)] 4 − 18.6 (17.8 − 82.7) [1.0 − 4.9 (8.7 − 43.4)] − Engine idle speed r/min 2.4L ENGINE 750 ± 100 − 3.0L ENGINE 700 ± 100 − Stationary steering effort N (lb) [Fluctuation allowance N (lb)] 30 (6.7) or less [5.9 − Oil pump pressure Oil pump relief pressure 8.3 − 9.5 (1,209 − 1,280) − Pressure under no-load conditions 0.8 − 1.0 (116 − 145) − Steering gear retention hydraulic pressure 8.3 − 9.5 (1,209 − 1,280) − Oil pressure switch operating pressure MPa (psi) OFF → ON 1.8 − 2.4 (261 − 348) − ON → OFF 0.8 − 2.4 (116 − 348) − Gear box total pinion torque N ⋅ m (in-lb) [Change in torque: 0.7 N ⋅ m (6.1 in-lb) or less] 0.8 − 1.9 (6.9 − 16.5) − Opening dimension of special tool MB991561 mm (in) 1.9 (0.07) − Band crimped width mm (in) 1.4 − 1.8 (0.06 − 0.07) − ITEMS SPECIFIED QUANTITY dm 3
(qt) Gear box Bearing MITSUBISHI POWER As required O-ring Oil seal Special tool (MB991213) Pinion and valve assembly seal ring Bellows Silicon grease As required Oil pump Power steering fluid MITSUBISHI POWER 0.8 (0.85) Friction surface of rotor vane, cam MITSUBISHI POWER As required O-ring |