|
|
Content .. 1143 1144 1145 1146 ..
ELECTRICAL-BODY AND CHASSIS 8-337 (5) If there is a place where the voltage suddenly changes to 0V, there is a broken wire between there and the power side. (6) Move the tester probe from the position where the voltage changes to 0V toward the power side and find where the voltage suddenly increases. REPAIR OF BROKEN HEAT WIRE (1) Clean broken wire tips with white gasoline. (2) Place masking tape along both sides of wire to be repaired. (3) Thoroughly mix the repair agent (Dupont paste No. 4817 or equivalent). (4) Using a fine tip brush, apply a small amount to the wire. (5) After a couple of minutes, remove the masking tape. (6) Allow to stand at least 24 hours. |