|
|
содержание .. 594 595 596 597 598 ..
Geely Emgrand X7. Manual part - 597
A. Connect fault diagnosis tester to the data link connector. B. Rotated ignition switch to ON position. C. Clear DTC code. D. Start and run the engine at idle speed to warm up the engine for at least 5min. E. Read the control system DTC code again. DTC codes still exist?
4 Troubleshooting 11.7.7.6 DTC U1400 U1410 U1420 U1430 U1501 U1601 DTC code Descriptions U10018 A/C message time-out and lost communication with A/C U10017 BCM message time-out and lost communication with BCM U10011 CAN network system integrity test failure U10010 Detect CAN BUS off state. Diagnostic steps: See 11.16.8 Diagnostic Information and procedures in "data communication system". 3 Use fault diagnosis tester to confirm if DTC is stored again. Yes Go to step 1 No 2387 |