Dodge Dakota (ND). Manual - part 500

SKREEM VERIFICATION

For a complete wiring diagram Refer to Section 8W.

Diagnostic Test

SKREEM VERIFICATION

NOTE: When entering the PIN, care should be taken because the SKREEM will only allow 3 consecutive
attempts to enter the correct PIN. If 3 consecutive incorrect PIN’s are entered the SKREEM will Lock Out the
scan tool. To exit Lock Mode, the ignition key must remain the Run position for I hour. All accessories must
be off. A battery charger connected to the battery during this time period is recommended.

1. Reconnect the previously disconnected components and connectors.

2. Obtain the vehicle’s unique Personal Identification Number (PIN) assigned to it’s original SKREEM. This num-
ber can be obtained from the vehicle invoice or from the DaimlerChrysler Customer Center (Phone 1-800-992-
1997).

3. With the scan tool, select Miscellaneous Functions, WCM/Wireless Control Module. Then select the desired
procedure and follow the display on the scan tool.

4. If the SKREEM was replaced, ensure all the customer’s key have been programmed to the new module.

5. With the scan tool, ease all DTCs. Perform 5 ignition key cycles, leaving the key on for at least 90 seconds
per cycle.

6. With the scan tool, read SKREEM DTC(s).

Are there any SKREEM DTC(s) present?

Yes

>> Repair not complete, refer to the appropriate symptom.

>> Repair is complete.

8Q - 94

VEHICLE THEFT SECURITY - ELECTRICAL DIAGNOSTICS

STANDARD PROCEDURE

SKREEM VERIFICATION

For a complete wiring diagram Refer to Section 8W.

Diagnostic Test

SKREEM VERIFICATION

1. Reconnect the previously disconnected components and connectors.

3. With the scan tool, select Miscellaneous Functions, WCM/Wireless Control Module. Then select the desired
procedure and follow the display on the scan tool.

4. If the SKREEM was replaced, ensure all the customer’s key have been programmed to the new module.

5. With the scan tool, ease all DTCs. Perform 5 ignition key cycles, leaving the key on for at least 90 seconds
per cycle.

6. With the scan tool, read SKREEM DTC(s).

Are there any SKREEM DTC(s) present?

Yes

>> Repair not complete, refer to the appropriate symptom.

>> Repair is complete.

VEHICLE THEFT SECURITY - ELECTRICAL DIAGNOSTICS

8Q - 95

WIPERS/WASHERS

TABLE OF CONTENTS

page