Dodge Dakota (ND). Manual - part 1164

 

  Index      Dodge     Dodge Dakota (ND) 2005 - service repair manual 2005 year

 

Search            

 

 

 

 

 

 

 

 

 

Content   ..  1162  1163  1164  1165   ..

 

 

Dodge Dakota (ND). Manual - part 1164

 

 

4. Connect the outside handle (3) and lock cylinder

(2) links.

5. Connect the lock knob (1) and the inside handle (2)

links.

6. Install the watershield. (Refer to 23 - BODY/DOOR

- FRONT/WATERSHIELD - INSTALLATION) (Refer
to 23 - BODY/DOOR - FRONT/WATERSHIELD -
INSTALLATION)

7. Adjust the latch as needed. (Refer to 23 - BODY/

DOOR - FRONT/LATCH - ADJUSTMENTS)

23 - 68

DOOR - FRONT

ND

ADJUSTMENTS

ADJUSTMENT

1. Locate access hole (3) and remove the trim plug

covering it.

2. Insert a 5/32-inch hex-wrench through hole and

into adjustment screw. Loosen screw.

3. Operate outside handle several times to release

any restriction because of mis-alignment.

4. Tighten adjustment screw to 3 N·m (30 in. lbs.).

5. Test handle for proper operation.

PANEL-TRIM

REMOVAL

1. If equipped, remove the manual window crank (2)

using a window crank removal tool (1).

2. Disconnect and isolate battery negative cable.

3. Remove the screw (2) at the interior handle.

4. Remove the screw (4) from the pull cup.

5. Remove the lower screws (5).

CAUTION: The door trim panel is attached to the
door by molded plastic retaining clips that are
integral to the door trim panel. Do not pull the
door trim panel directly off of the door or damage
to the trim panel and/or the power switch assem-
bly will occur.

6. Lift the door trim panel straight upward to discon-

nect the molded plastic retaining clips (6) from the
door.

ND

DOOR - FRONT

23 - 69

7. Disconnect the interior handle (3) actuator rod (1)

from the handle (2).

8. Disconnect the electrical connectors (2) for the win-

dow switch assembly (3), if equipped.

9. Disconnect the trim panel speaker electrical con-

nector (1), if equipped.

23 - 70

DOOR - FRONT

ND

INSTALLATION

1. Connect the trim panel speaker electrical connector

(1), if equipped.

2. Connect the electrical connectors (2) for the win-

dow switch assembly (3), if equipped.

3. Connect the interior handle (3) actuator rod (1) to

the handle (2).

ND

DOOR - FRONT

23 - 71

 

 

 

 

 

 

 

Content   ..  1162  1163  1164  1165   ..