Index Chrysler Chrysler Sebring, Stratus sedan, Sebring Convertible - service repair manual 2001-2007 year
|
|
Symptom: DRIVER DOOR CENTRAL LOCK (ARM)/UNLOCK (DISARM) SWITCH FAILURE When Monitored and Set Condition: DRIVER DOOR CENTRAL LOCK (ARM)/UNLOCK (DISARM) SWITCH FAILURE When Monitored: Continuously Set Condition: If the BCM detect a signal on the Driver Cylinder Lock Switch Mux circuit for over 10 seconds this code will set and will ignore the offending input until it is corrected. POSSIBLE CAUSES BINDING DRIVER CYLINDER LOCK SWITCH DRIVER CYLINDER LOCK SWITCH SHORTED TO VOLTAGE DRIVER CYLINDER LOCK SWITCH MUX CIRCUIT SHORTED TO VOLTAGE WIRING HARNESS INTERMITTENT DEFECT BODY CONTROL MODULE - DRIVER CYLINDER LOCK SWITCH FAILURE TEST ACTION APPLICABILITY 1 With the DRBIII t, erase DTC’s. Insert the key in the Driver Cylinder Lock Switch and rotate the key to the lock and t, read DTC’s. Did this DTC reset? All Yes → Go To 2 No → Go To 6 2 Insert the key in the Driver Cylinder Lock Switch and rotate the key to the lock and All Yes → Repair or replace the Driver Cylinder Lock Switch as necessary. Perform BODY VERIFICATION TEST - VER 1. No → Go To 3 3 Disconnect the Driver Cylinder Lock Switch harness connector. 9Body Computer9 then 9Sensors9 and observe the Dr Door Disarm SW voltage All Yes → Go To 4 No → Replace the Driver Cylinder Lock Switch. Perform BODY VERIFICATION TEST - VER 1. 397 POWER DOOR LOCKS/RKE |