|
|
TEST VER 1A VERIFICATION TEST - AIRBAG 1. Remove all jumper wires and reconnect all previously disconnected components (except the battery). 2. Turn the ignition key on and reconnect the battery. 3. Connect the DRB to the data link connector (use the most current software available). 4. Use the DRB to erase the stored codes. 5. Turn the ignition off and wait 15 seconds before turning the ignition on. 6. Wait one minute, and read the active codes. 7. Does the DRB display any active codes? YES - Perform Airbag Test 1A. 8. With the DRB read the stored codes. 9. Does the DRB display any stored codes? YES - Perform Airbag Test 1A. V R I F I C T I O N T E T 734 |