Index Chrysler Chrysler 300M / Concorde / Interpid / LHS, Dodge Interpid - service repair manual 2000-2004 year
|
|
INSTALLATION AIR CONDITIONING BELT - NEW WARNING: DO NOT REMOVE A/C BELT TENSIONER NOTE: Verify that torsion spring position is in the (1) Insert a 1/2” drive breaker bar into the square opening on the tensioner. Hold counterclockwise pres- (2) Carefully release spring load of the torsion spring on the tensioner. (3) Remove pivot bolt, tensioner, and spring from front timing cover. (4) Insert spring arm into the NEW belt position on the tensioner (Fig. 4). (5) Install torsion spring, tensioner, and pivot bolt. this time. (7) Using a 1/2” drive breaker bar, apply counter- clockwise pressure until locking bolt can be installed. (8) Install the NEW belt by rotating the tensioner counterclockwise until the NEW belt can be installed (9) Release tensioner and remove breaker bar. Belt is automatically adjusted with the tensioner’s torsion (10) Tighten tensioner locking bolt and pivot bolt to 28 N·m (250 in. lbs.) (Fig. 2). (11) Install generator/power steering belt. Refer to GENERATOR/POWER STEERING BELT INSTAL- AIR CONDITIONING BELT - USED NOTE: A “used belt” is considered having more NOTE: Perform steps 1–7 to change the tensioner (1) Insert a 1/2” drive breaker bar into the square opening on tensioner. Hold counterclockwise pressure (2) Carefully release the tension of spring on ten- sioner. Fig. 3 Drive Belt Wear Pattern 1 - NORMAL CRACKS - BELT OK Fig. 4 Air Conditioning Belt Tensioner Spring Position 1 - TENSIONER LH ACCESSORY DRIVE 7 - 15 DRIVE BELTS - 2.7L (Continued) |