Subaru Legacy III (2000-2003 year). Manual - part 106
EN(H4SO)-36
ENGINE (DIAGNOSTICS)
SUBARU SELECT MONITOR
6. READ FREEZE FRAME DATA FOR ENGINE. (OBD MODE)
1) On the «Main Menu» display screen, select the {Each System Check} and press the [YES] key.
2) On the «System Selection Menu» display screen, select the {Engine Control System} and press the [YES]
key.
3) Press the [YES] key after displayed the information of engine type.
4) On the «Engine Diagnosis» display screen, select the {OBD System} and press the [YES] key.
5) On the «OBD Menu» display screen, select the {Freeze Frame Data} and press the [YES] key.
• A list of the support data is shown in the following table.
NOTE:
For detailed operation procedure, refer to the SUBARU SELECT MONITOR OPERATION MANUAL.
Contents
Display
Unit of measure
Diagnostic trouble code (DTC) for freeze frame data
Freeze frame data
DTC
Air fuel ratio control system for bank 1
Fuel system for Bank 1
ON or OFF
Engine load data
Engine Load
%
Engine coolant temperature signal
Coolant Temp.
°
C or
°
F
Short term fuel trim by front oxygen (A/F) sensor
Short term fuel trim B1
%
Long term fuel trim by front oxygen (A/F) sensor
Long term fuel trim B1
%
Intake manifold absolute pressure signal
Mani. Absolute Pressure
mmHg or kPa or inHg or
psig
Engine speed signal
Engine Speed
rpm
Vehicle speed signal
Vehicle Speed
km/h or MPH