|
|
1F-188 ENGINE CONTROLS SSANGYONG Y158 DIAGNOSTIC TROUBLE CODE (DTC) P0152 O2 BANK 2 SENSOR 3 HIGH VOLTAGE (3.2L DOHC) Circuit Description In order to control emissions, a catalytic converter is The Engine Control Module (ECM) has the ability to If the O2S 3 pigtail wiring, connector, or terminal is Any attempt to repair the wires, connector, or terminal Conditions for Setting the DTC ••••• O2S 3 voltage is greater than 1.05 volts. ••••• Lambda control status is enabled. ••••• P0155; lambda heater status is active/faultless. Action Taken When the DTC Sets ••••• The Malfunction Indicator Lamp (MIL) will illuminate ••••• The ECM will record operating conditions at the time ••••• A history DTC is stored. Conditions for Clearing the MIL/DTC ••••• The MIL will turn off after three consecutive driving ••••• A history DTC will clear after 40 consecutive warm- ••••• The DTC(s) can be cleared by using the scan tool. Diagnostic Aids An intermittent may be caused by rubbed-through wire ••••• Exhaust system - Inspect the exhaust system for ••••• Poor connection or damaged harness - Ensure that ••••• Check for the following conditions: ••••• improper mating ••••• Broken locks ••••• Improperly formed ••••• Damaged terminals ••••• Poor terminal-to-wire connection ••••• Damaged harness ••••• Intermittent test - Observe the O2S 3 on the scan YAB1F150 |