|
|
6E1–239 X22SE 2.2L ENGINE DRIVEABILITY AND EMISSION Step No Yes Value(s) Action 10 Check for proper ignition voltage output with a spark Was a problem found? — Verify repair Go to Step 11 11 1. Remove the spark plugs and check for gas or oil fouling cracks, wear, improper gap, burned 2. If spark plugs are fouled, the cause of fouling must be determined before replacing the spark plugs. Was a problem found? — Verify repair Go to Step 12 12 Check for a loose ignition control module ground. Was a problem found? — Verify repair Go to Step 13 13 1. Check the ignition coil secondary resistance. of resistance. Did the coil require replacement? 9 k W –12 k W Verify repair Go to Step 14 14 Check IAC operation. Perform the procedure in the Was a problem found? — Verify repair Go to Step 15 15 Check for water or alcohol contaminated fuel. Was a problem found? — Verify repair Go to Step 16 16 Perform the procedure in Fuel System Pressure Test to Was a problem found? — Verify repair Go to Step 17 17 Check for the following engine mechanical problems D Low compression D Leaking cylinder head gaskets D Worn camshaft D Camshaft drive belt slipped or stripped Was a problem found? — Verify repair Go to Step 18 18 1. Review all diagnostic procedures within this table. malfunctions have been found, review/inspect the D Visual/physical inspection D Tech 2 data D Freeze Frame data/Failure Records buffer D All electrical connections within a suspected Was a problem found? — Verify repair Contact Technical Assistance |