|
|
6E2–282 6VD1 3.2L ENGINE DRIVEABILITY AND EMISSIONS D Bank 1 sensor 1 is mounted on the exhaust pipe TS22912 D Bank 2 sensor 1 is mounted on the exhaust pipe TS22914 3. Disconnect the pigtail from the wiring harness. IMPORTANT: The pigtail is permanently attached to the sensor. Be careful not to pull the wires out. NOTE: Do not use a torch to remove an HO2S unless the 4. Remove the sensor from the exhaust pipe. D Because of the expansion and contraction of the ° C (120 ° F). TS23739 Inspection Procedure All four sensors are identical. Inspect each in the same 1. Inspect the pigtail and the electrical connector for grease, dirt, corrosion, and bare wires or worn 2. Inspect the louvered end of the sensor for grease, dirt, or other contaminations. TS23739 |