Nissan Altima L32. Manual - part 1130

DOES NOT OPERATE BY KEY CYLINDER SWITCH

PWC-287

< SYMPTOM DIAGNOSIS >

[LH&RH FRONT ANTI-PINCH-COUPE]

C

D

E

F

G

H

I

J

L

M

A

B

PWC

N

O

P

DOES NOT OPERATE BY KEY CYLINDER SWITCH

Diagnosis Procedure

INFOID:0000000004205133

1.

 PERFORM INITIALIZATION PROCEDURE

Perform initialization procedure.

Refer to 

PWC-190, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair Require-

ment"

.

Is the inspection result normal?

YES

>> GO TO 2

NO

>> Repair or replace the malfunctioning parts.

2.

 CHECK DOOR LOCK ASSEMBLY LH (KEY CYLINDER SWITCH)

Check door lock assembly LH (key cylinder switch). 

Refer to 

PWC-214, "Component Function Check"

.

Is the inspection result normal?

YES

>> Inspection End.

NO

>> Check intermittent incident. Refer to 

GI-42, "Intermittent Incident"

.

PWC-288

< SYMPTOM DIAGNOSIS >

[LH&RH FRONT ANTI-PINCH-COUPE]

KEYLESS POWER WINDOW DOWN DOES NOT OPERATE

KEYLESS POWER WINDOW DOWN DOES NOT OPERATE

Diagnosis Procedure

INFOID:0000000004205134

1.

 CHECK INTELLIGENT KEY FUNCTION

Check Intelligent Key function.

Refer to  

SEC-16, "System Description"

.

Is the inspection result normal?

YES

>> Check intermittent incident. Refer to 

GI-42, "Intermittent Incident"

.

NO

>> Replace BCM. Refer to 

BCS-96, "Removal and Installation"

.

POWER WINDOW LOCK SWITCH DOES NOT FUNCTION

PWC-289

< SYMPTOM DIAGNOSIS >

[LH&RH FRONT ANTI-PINCH-COUPE]

C

D

E

F

G

H

I

J

L

M

A

B

PWC

N

O

P

POWER WINDOW LOCK SWITCH DOES NOT FUNCTION

Diagnosis Procedure

INFOID:0000000004205135

1.

 REPLACE MAIN POWER WINDOW AND DOOR LOCK/UNLOCK SWITCH 

Replace main power window and door lock/unlock switch. 

Refer to 

PWC-291, "Removal and Installation"

. After that, 

PWC-199, "POWER WINDOW MAIN SWITCH :

Special Repair Requirement"

.

Is the inspection result normal?

YES

>> Inspection End.

NO

>> Check intermittent incident. Refer to 

GI-42, "Intermittent Incident"

.

PWC-290

< ON-VEHICLE MAINTENANCE >

[LH&RH FRONT ANTI-PINCH-COUPE]

PRE-INSPECTION FOR DIAGNOSTIC

ON-VEHICLE MAINTENANCE

PRE-INSPECTION FOR DIAGNOSTIC

Basic Inspection

INFOID:0000000004205137

BASIC INSPECTION

1.

INSPECTION START

1. Check the service history.

2. Check the following parts.

• Fuse/circuit breaker blown.

• Poor connection, open or short circuit of harness connector.

• Battery voltage.
Is the inspection result normal?

YES

>> Inspection end.

NO

>> Repair or replace the malfunctioning parts.