Nissan Terrano r20e. Manual - part 204
General Specifications
Engine speed
Unit: rpm
Engine
TD27Ti
Idle speed
A/C: ON
725
845
Maximum engine speed
5,500
Pump numbers
Engine
Part number
Pump assembly num-
ber
TD27Ti
16700 7F410
104701-2032
RNP11
Pump data is not yet available.
Refer to CALIBRATION STANDARD published
by BOSCH.
Injection Nozzle
INSPECTION AND ADJUSTMENT
Injection nozzle assembly
Unit: kPa (bar, kg/cm
2
, psi)
Initial injection pressure
New
12,749 - 13,730 (127.5 - 137.3, 130 - 140,
1,849 - 1,991)
Used
12,259 - 12,749 (122.6 - 127.5, 120 - 135,
1,706 - 1,849)
Inspection and Adjustment
Plunger lift
mm (in)
at TDC
0.275 ± 0.02
(0.0108) ± (0.0008)
Idle speed
rpm
(“N” or “P” position)
725 ± 25
MASS AIR FLOW SENSOR
Supply voltage
V
Approximately 5
Output voltage
V
1.5 - 2.7*
*: Engine is warmed up sufficiently and idling under no-load.
ENGINE COOLANT TEMPERATURE
SENSOR
Temperature °C (°F)
Resistance k
Ω
20 (68)
2.1 - 2.9
50 (122)
0.68 - 1.00
90 (194)
0.236 - 0.260
CONTROL SLEEVE POSITION SENSOR
Resistance [at 25°C (77°F)]
Ω
Approximately 6.1
INJECTION TIMING CONTROL VALVE
Resistance [at 25°C (77°F)]
Ω
Approximately 15
NEEDLE LIFT SENSOR
Resistance [at 25°C (77°F)]
Ω
Approximately 105
CRANKSHAFT POSITION SENSOR (TDC)
Resistance [at 25°C (77°F)]
Ω
Approximately 900
GLOW PLUG
Resistance [at 25°C (77°F)]
Ω
0.5
ACCELERATOR POSITION SENSOR
Throttle valve conditions
Resistance k
Ω
[at 25°C (77°F)]
Completely closed
Approximately 1.2
Partially open
1.2 - 1.9
Completely open
Approximately 1.9
FUEL TEMPERATURE SENSOR
Temperature °C (°F)
Resistance k
Ω
25 (77)
Approximately 1.9
SERVICE DATA AND SPECIFICATIONS (SDS)
TD27Ti
EC-453