|
|
Content .. 1181 1182 1183 1184 ..
C1601 BATTERY POWER SUPPLY STC-21 < DTC/CIRCUIT DIAGNOSIS > C D E F H I J K L M A B STC N O P C1601 BATTERY POWER SUPPLY DTC Logic INFOID:0000000009650871 DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1. PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and >> GO TO 2. 2. DTC REPRODUCTION PROCEDURE With CONSULT 1. Turn the ignition switch OFF to ON. 2. Perform “EPS” self-diagnosis. Is DTC “C1601” detected? YES >> Proceed to diagnosis procedure. Refer to NO >> INSPECTION END Diagnosis Procedure INFOID:0000000009650872 1. CHECK POWER STEERING CONTROL MODULE GROUND CIRCUIT 1. Turn ignition switch OFF. 2. Disconnect power steering control module harness connector. 3. Check continuity between power steering control module harness connector terminal and ground. Is the inspection result normal? YES >> GO TO 2. NO >> Repair open circuit or short to ground or short to power in harness or connectors, and repair or replace error-detected parts. 2. CHECK POWER STEERING CONTROL MODULE POWER SUPPLY CIRCUIT (1) 1. Check voltage between power steering control module harness connector terminals and ground. 2. Turn ignition switch ON. CAUTION: Never start the engine. 3. Check voltage between power steering control module harness connector terminals and ground. DTC Display item Malfunction detected condition Possible cause C1601 BATTERY VOLT When a power supply voltage to the power steer- • Harness or connector ule • Fuse Power steering control module — Continuity Connector Terminal E33 2 Ground Existed Power steering control module — Voltage (Approx.) Connector Terminal E33 1 Ground 8.5 – 18.5 V |