|
|
CLUTCH PEDAL POSITION SWITCH EC-307 < DTC/CIRCUIT DIAGNOSIS > [HR16DE] C D E F G H I J K L M A EC N P O CLUTCH PEDAL POSITION SWITCH Component Function Check INFOID:0000000009642392 1. CHECK CLUTCH PEDAL POSITION SWITCH FUNCTION With CONSULT 1. Turn ignition switch ON. 2. Select “ENGINE” using CONSULT. 3. Select “CLUTCH P/P SW” in “DATA MONITOR” mode. 4. Check “CLUTCH P/P SW” indication under the following conditions. Without CONSULT 1. Turn ignition switch ON. 2. Check the voltage between ECM harness connector and ground. Is the inspection result normal? YES >> INSPECTION END NO >> Go to Diagnosis Procedure INFOID:0000000009642393 1. CHECK CLUTCH PEDAL POSITION SWITCH GROUND CIRCUIT FOR OPEN AND SHORT 1. Turn ignition switch OFF. 2. Disconnect clutch pedal position switch harness connector. 3. Check the continuity between clutch pedal position switch harness connector and ground. 4. Also check harness for short to power. YES >> GO TO 2. NO >> Repair open circuit or short to power in harness or connectors. 2. CHECK CLUTCH PEDAL POSITION SWITCH INPUT SIGNAL CIRCUIT FOR OPEN AND SHORT 1. Disconnect ECM harness connector. 2. Check the continuity between clutch pedal position switch harness connector and ECM harness connec- tor. 3. Also check harness for short to ground and short to power. Monitor item Condition Indication CLUTCH P/P SW Clutch pedal Fully released OFF Fully depressed ON ECM Condition Voltage + – Connector Terminal Connector Terminal E16 92 (Clutch pedal position switch signal) E16 108 Clutch pedal Fully released Approx. 0V Fully depressed Battery voltage Clutch pedal position switch Ground Continuity Connector Terminal E48 4 Ground Existed Clutch pedal position switch ECM Continuity Connector Terminal Connector Terminal E48 3 E16 92 Existed |