|
|
CHG-24 < DTC/CIRCUIT DIAGNOSIS > L TERMINAL CIRCUIT (OPEN) L TERMINAL CIRCUIT (OPEN) Description INFOID:0000000009755967 The “L” terminal circuit controls the charge warning lamp. The charge warning lamp turns ON when the igni- tion switch is set to ON or START. When the generator is providing sufficient voltage with the engine running, the charge warning lamp turns OFF. If the charge warning lamp illuminates with the engine running, a malfunc- tion is indicated. Diagnosis Procedure INFOID:0000000009755968 Regarding Wiring Diagram information. Refer to . 1. CHECK “L” TERMINAL CONNECTION 1. Turn ignition switch OFF. 2. Check if “L” terminal is clean and tight. YES >> GO TO 2. NO >> Repair “L” terminal connection. Confirm repair by performing complete Charging system test using EXP-800 NI or GR8-1200 NI (if available). Refer to applicable Instruction Manual for proper testing procedures. 2. CHECK “L” TERMINAL CIRCUIT (OPEN) 1. Disconnect the generator connector. 2. Apply ground to generator harness connector terminal. 3. Check condition of the charge warning lamp with the ignition switch in the ON position. Does it illuminate? YES >> “L” terminal circuit is normal. Refer to CHG-14, "Work Flow (With EXP-800 NI or GR8-1200 NI)" CHG-17, "Work Flow (Without EXP-800 NI or GR8-1200 NI)" . NO >> GO TO 3. 3. CHECK HARNESS CONTINUITY (OPEN CIRCUIT) 1. Disconnect the battery cable from the negative terminal. 2. Disconnect the combination meter connector. 3. Check continuity between generator harness connector and combination meter harness connector. is the inspection result normal? YES >> GO TO 4. NO >> Repair or replace the harness or connectors. 4. CHECK POWER SUPPLY CIRCUIT 1. Connect the battery cable to the negative terminal. 2. Check voltage between combination meter harness connector and ground. Generator Ground Condition Connector Terminal Ignition switch position Charge warning lamp F15 2 ON Illuminate Generator Combination meter Continuity Connector Terminal Connector Terminal F15 2 M24 38 Yes |