|
|
PWC-40 < DTC/CIRCUIT DIAGNOSIS > [LH FRONT ONLY AUTO DOWN] POWER WINDOW MOTOR 2. Disconnect front power window motor RH. 3. Turn ignition switch ON. 4. Check voltage between front power window motor RH connector D104 and ground. Is the inspection result normal? YES >> GO TO 3. NO >> GO TO 2. 2. CHECK HARNESS CONTINUITY 1. Turn ignition switch OFF. 2. Disconnect power window and door lock/unlock switch RH. 3. Check continuity between power window and door lock/unlock switch RH connector D125 and front power window motor RH connector D104. 4. Check continuity between power window and door lock/unlock switch connector D125 and ground. Is the inspection result normal? YES >> Replace power window and door lock/unlock switch RH. Refer to PWC-63, "Removal and Installa- . NO >> Repair or replace the harness or connectors. 3. CHECK FRONT POWER WINDOW MOTOR RH Check front power window motor RH. PWC-40, "PASSENGER SIDE : Component Inspection" . Is the inspection result normal? YES >> Check intermittent incident. Refer to GI-49, "Intermittent Incident" . NO >> Replace front power window motor RH. Refer to GW-14, "Removal and Installation" PASSENGER SIDE : Component Inspection INFOID:0000000009176134 COMPONENT INSPECTION COMPONENT INSPECTION 1. CHECK FRONT POWER WINDOW MOTOR RH Check motor operation by connecting the battery voltage directly to front power window motor RH D104. Terminal Front power window motor RH condition Voltage (V) (Approx.) (+) (–) Front power window motor RH connector Terminal D104 1 Ground UP Battery voltage DOWN 0 2 UP 0 DOWN Battery voltage Power window and door lock/un- lock switch RH connector Terminal Front power window motor RH connector Terminal Continuity D125 6 D104 2 Yes 7 1 Power window and door lock/unlock switch RH connector Terminal Ground Continuity D125 6 No 7 |