|
|
LAN ADP BRANCH LINE CIRCUIT LAN-181 < DTC/CIRCUIT DIAGNOSIS > [CAN SYSTEM (TYPE 4)] C D E F G H I J K L B A O P N ADP BRANCH LINE CIRCUIT Diagnosis Procedure INFOID:0000000009175072 1. CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the following terminals and connectors for damage, bend and loose connection (unit side and con- nector side). - Driver seat control unit - Harness connector B200 - Harness connector B54 - CAN gateway (Models with around view monitor) Is the inspection result normal? YES-1 >> Models with around view monitor: GO TO 2. YES-2 >> Models without around view monitor: GO TO 3. NO >> Repair the terminal and connector. 2. CHECK HARNESS CONTINUITY (OPEN CIRCUIT) 1. Disconnect the connector of CAN gateway. 2. Check the continuity between the CAN gateway harness connector terminals. Is the inspection result normal? YES >> GO TO 3. NO >> Check the harness and repair the root cause (CAN communication circuit 2 side). 3. CHECK HARNESS FOR OPEN CIRCUIT 1. Connect the connector of CAN gateway. (Models with around view monitor) 2. Disconnect the connector of driver seat control unit. 3. Check the resistance between the driver seat control unit harness connector terminals. Is the measurement value within the specification? YES >> GO TO 4. NO >> Repair the driver seat control unit branch line. 4. CHECK POWER SUPPLY AND GROUND CIRCUIT Check the power supply and the ground circuit of the driver seat control unit. Refer to CONTROL UNIT : Diagnosis Procedure" Is the inspection result normal? YES (Present error)>>Replace the driver seat control unit. Refer to ADP-161, "Removal and Installation" YES (Past error)>>Error was detected in the driver seat control unit branch line. NO >> Repair the power supply and the ground circuit. CAN gateway harness connector Continuity Connector No. Terminal No. M5 4 6 Existed 10 12 Existed Driver seat control unit harness connector Resistance ( Ω) Connector No. Terminal No. B209 16 32 Approx. 54 – 66 |