|
|
LAN MAIN LINE BETWEEN ADP AND PWBD CIRCUIT LAN-145 < DTC/CIRCUIT DIAGNOSIS > [CAN SYSTEM (TYPE 3)] C D E F G H I J K L B A O P N MAIN LINE BETWEEN ADP AND PWBD CIRCUIT Diagnosis Procedure INFOID:0000000009175037 1. CHECK HARNESS CONTINUITY (OPEN CIRCUIT) 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Disconnect the following harness connectors. - ECM (Models without around view monitor) - CAN gateway (Models with around view monitor) - Harness connector B54 and B200 - Automatic back door control module 4. Check the continuity between the harness connector and the automatic back door control module harness connector. Is the inspection result normal? YES (Present error)>>Check CAN system type decision again. YES (Past error)>>Error was detected in the main line between the driver seat control unit and the automatic back door control module. NO >> Repair the main line between the harness connector B54 and the automatic back door control module. Harness connector Automatic back door control module harness connector Continuity Connector No. Terminal No. Connector No. Terminal No. B54 1 B55 24 Existed 2 12 Existed |