|
|
EXL-108 < DTC/CIRCUIT DIAGNOSIS > HEADLAMP (HI) CIRCUIT HEADLAMP (HI) CIRCUIT Description INFOID:0000000009175365 The IPDM E/R (intelligent power distribution module engine room) controls the headlamp high relay based on inputs from the BCM over the CAN communication lines. When the headlamp high relay is energized, power flows through fuses 34 and 35, located in the IPDM E/R. Power then flows to the front combination lamps to the headlamp high beam. Component Function Check INFOID:0000000009175366 1. CHECK HEADLAMP (HI) OPERATION WITHOUT CONSULT 1. Start IPDM E/R auto active test. Refer to PCS-8, "Diagnosis Description" . 2. Check that the headlamp switches to the high beam. WITH CONSULT 1. Select EXTERNAL LAMPS of IPDM E/R active test item. 2. While operating the test items, check that the headlamp switches to the high beam. Does the headlamp switch to the high beam? YES >> Headlamp (HI) circuit is normal. NO >> Refer to EXL-108, "Diagnosis Procedure" . Diagnosis Procedure INFOID:0000000009175367 Regarding Wiring Diagram - Refer to 1. CHECK HEADLAMP (HI) FUSES 1. Turn the ignition switch OFF. 2. Check that the following fuses are not blown. Is the fuse blown? YES >> Replace the blown fuse after repairing the affected circuit. NO >> GO TO 2. 2. CHECK HEADLAMP (HI) OUTPUT VOLTAGE CONSULT ACTIVE TEST 1. Turn the ignition switch OFF. 2. Disconnect the front combination lamp harness connector E233 or E238. 3. Turn the ignition switch ON. 4. Select EXTERNAL LAMPS of IPDM E/R active test item. 5. With EXTERNAL LAMP ON, check the voltage between the combination lamp harness connector and ground. HI : Headlamp switches to the high beam. OFF : Headlamp OFF Unit Location Fuse No. Capacity Headlamp HI (LH) IPDM E/R 35 10A Headlamp HI (RH) IPDM E/R 34 10A (+) ( −) Voltage Connector Terminal RH E238 3 Ground Battery voltage LH E233 |