|
|
ADP-100 < DTC/CIRCUIT DIAGNOSIS > LIFTING SWITCH (REAR) LIFTING SWITCH (REAR) Description INFOID:0000000009176594 Lifting switch (rear) is equipped to the power seat switch LH on the seat frame. The operation signal is inputted to the driver seat control unit when the lifting switch (rear) is operated. Component Function Check INFOID:0000000009176595 1. CHECK FUNCTION 1. Select “LIFT RR SW-UP”, “LIFT RR SW-DN” in “DATA MONITOR” mode with CONSULT. 2. Check lifting switch (rear) signal under the following conditions. Is the inspection result normal? YES >> Inspection End. NO >> Perform diagnosis procedure. Refer to ADP-100, "Diagnosis Procedure" Diagnosis Procedure INFOID:0000000009176596 Regarding Wiring Diagram information, refer to ADP-55, "WITH AROUND VIEW MONITOR : Wiring Diagram" or ADP-40, "WITHOUT AROUND VIEW MONITOR : Wiring Diagram" . 1. CHECK LIFTING SWITCH (REAR) SIGNAL 1. Turn ignition switch OFF. 2. Check voltage between driver seat control unit harness connector and ground. Is the inspection result normal? YES >> GO TO 5. NO >> GO TO 2. 2. CHECK LIFTING SWITCH (REAR) CIRCUIT 1. Turn ignition switch OFF. 2. Disconnect driver seat control unit and power seat switch LH. 3. Check continuity between driver seat control unit harness connector and power seat switch LH harness connector. Monitor item Condition Status LIFT RR SW-UP Lifting switch rear (up) Operate ON Release OFF LIFT RR SW-DN Lifting switch rear (down) Operate ON Release OFF (+) (–) Condition Voltage (V) (Approx.) Driver seat control unit Connector Termi- nals B209 6 Ground Lifting switch (rear) Operate (down) 0 Release Battery voltage 22 Operate (up) 0 Release Battery voltage |