|
|
FRONT DRIVE SHAFT BOOT FAX-13 < REMOVAL AND INSTALLATION > C E F G H I J K L M A B FAX N O P • Be careful not to touch the inside of the boot with a tip of tool. 11. Secure the large and small ends of the boot with boot bands using the boot band crimping tool (A) [SST: KV40107300 ( — )]. CAUTION: Never reuse boot band. NOTE: 12. Secure joint sub-assembly and housing assembly, and then make sure that they are in the correct position when rotating CAUTION: Never reuse boot band. 13. Clean the matching surface of wheel hub lock nut and wheel hub and bearing assembly. CAUTION: Never apply lubricating oil to these matching surface. 14. Clean the matching surface of drive shaft and wheel hub and bearing assembly. CAUTION: Apply paste [service parts (440037S000)] to cover entire flat 15. Insert drive shaft to wheel hub and bearing assembly, and then temporarily tighten wheel hub lock nut. 16. Install strut assembly to steering knuckle. Refer to . 17. Install disc rotor. Refer to BR-36, "BRAKE CALIPER ASSEMBLY : Removal and Installation" 18. Install caliper assembly to steering knuckle. Refer to BR-35, "BRAKE CALIPER ASSEMBLY : Exploded . 19. Install lock plate to strut assembly. Refer to BR-20, "FRONT : Exploded View" . 20. Install wheel sensor and sensor harness to steering knuckle. Refer to . 21. Tighten the wheel hub lock nut to the specified torque. Refer to . NOTE: removing wheel hub and bearing assembly and axle housing. 22. Install cotter pin. Refer to CAUTION: JPDIF0012ZZ A : 7.0 mm (0.276 in) or less Amount paste : 1.0 – 3.0 g (0.04 – 0.10 oz) JPDIF0268ZZ JPDIG0122ZZ Revision: 2012 March 2011 Murano CrossCabriolet |